Electrical cable feedthroughs
Harax PG 13,5/ panel feed through / 3-po Panel feed through, With solder termination, for front mounting
If your application requires the transfer of signals, fluids or electrical currents, you may wish to consider investing in this item. This is possible through a feedthrough that has been vacuum-sealed ...
Conax Technologies manufactures high pressure seals [up to 20,000 PSI(2067 Bar) at 68°F(20°C)] for electrode feedthroughs. These high pressure seals are designed for installation onto the pressure vessel wall using threaded ...
... : > 50% Dielectric strength: 60 kV/mm Flame resistance: V2 UL94 (internal test) Application: for passing a cable through a wall with cable clamp.
Conax Technologies presents PL range of sealing glands. They allow passing of numerous insulated conductors through a single gland/entry with soft seal technology. They are suitable for both pressure as well as vacuum applications. Grade ...
High Pressure, High Voltage - Ceramic-to-Metal Sealed Feed Through Sealed for 1,000 psi differential pressure Leak rate test: 2x10-8 cc/sec. He. @ 2,000 PSIA pressure High current, high voltage (4 KVDC) Copper electrodes Au/Cu/Ni braze ...
... Series 41 Penetrators are suitable where a watertight electrical penetration is required through a bulkhead. Series 41 Penetrators consist of the penetrator stainless steel body, a length of molded cable ...
Mixed-use Portplate assembly combines DuctorSeal thermocouple vacuum feedthroughs, circular mil-Spec PotCon connectors, high-frequency SMA PotCons and D-Sub PotCons.
These electrical power feedthroughs are rated up to 8000V. The various conductors are insulated with alumina and rated up to 800V. They are designed to be welded into a suitable through-hole in a flange.
Your suggestions for improvement:
Receive updates on this section every two weeks.