{{product.productLabel}} {{product.model}}
{{#if product.featureValues}}{{product.productPrice.formattedPrice}} {{#if product.productPrice.priceType === "PRICE_RANGE" }} - {{product.productPrice.formattedPriceMax}} {{/if}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
{{product.productLabel}} {{product.model}}
{{#if product.featureValues}}{{product.productPrice.formattedPrice}} {{#if product.productPrice.priceType === "PRICE_RANGE" }} - {{product.productPrice.formattedPriceMax}} {{/if}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
... is a converter developed by Sichuan Odot Automation System Co., LTD between RS232/485/422 and TCP/UDP.This protocol converter can easily connect serial port devices to Ethernet and realize network upgrade ...
Isolated Converters with Programmable 3-Color LCD Display The CN-6000 series isolated converters feature 12-segment, programmable 3-color (red, green, yellow) negative LCD displays for clear status ...
Z-4TC-D allows to acquire up to N.4 Thermocouple sensors (J, K, E, N, S, R ,B ,T) through a PLC with only digital input/output. The PLC interface is based on three PNP-type signals suited for connection to most PLCs available ...
SENECA | Automation Interfaces
... input and two relays common SPST 3 A@ 250Vac, 3 A@ 30Vdc. The input can be configured as voltage, current, potentiometer, thermocouples or thermoresistances. The current input can be set in passive or active mode in order ...
SENECA | Automation Interfaces
K109PT is a converter for Thermoresistance PT100 with 2,3,4 wires and provides a mA/V standard output signal. It’s completely confi gurable through dip switches. A 3-way galvanic isolation among Power supply // input ...
SENECA | Automation Interfaces
S1XMmM Universal Current / Voltage Converter, universal sensor input, Analog Output and RS485 Modbus RTU, RMS, AC and DC measurement, Min / Max and Average measurement, Frequency and Crest factor measurement, temperature ...
SIL 2 TEMPERATURE SIGNAL CONVERTER, MULTIFUNCTION DESCRIPTION The single channel Temperature Signal Converter D6072S accepts a low level dc signal from millivolt, thermocouple or resistance/RTD ...
GM International srl
Temperature converter to connect up to four different resistance temperature sensors in dual cable technology with a resolution in 0.1 K. The addressing of the four temperature sensors is done via four M-Bus addresses ...
... Series head type temperature converters are electronic units designed by using microcontroller, inside plastic roller, capable of being installed inside thermocouple or resistance thermometer head. They ...
... actuators, relays, etc. • Counters Up/Down with inputs for Encoders • Configurable inputs Pt 100, mV, 0...4-20 mA • Inputs for thermocouples (E, J, K, T, S, R, B and N) • A/D conversion 16 bit. Accuracy 0.1% • D/A conversion ...
31712-00 type are digital converters for a rod head using the 2-wire technique Input : PT 100 ohm or thermocouple J K T R S B or mv Output: 4/20 mA programmable for scale, response time and input type ...
31713-00 type are 4/20 mA programmable converters using the two-wire technique with a local display assembled in an IP 65 epoxy painted aluminum case Input: thermocouple JKTRSB with PT 100 Ohm probe . Output ...
The KOS206TC is a cost effective "smart" in head converter that accepts thermocouple temperature sensors and converts sensor output over a configured range to a standard industrial (4 to 20) mA transmission ...
DITEL
The universal isolated converter DAT4530/AC is able to measure and linearise voltage, current and resistance signals, potentiometers and the standard thermocouples and RTDs with, if required, the cold ...
DATEXEL SRL
TC converter High accuracy, better than 0.1% of span Slimline housing of 6.1 mm Excellent EMC performance and 50/60 Hz noise suppression Selectable < 30 ms / 300 ms response time Pre-calibrated ...
Universal programmable converter with threshold relay function. Configurable via PC using the ProgressX Manager software and micro USB standard or by the BlueSet removable display. Input: Universal Voltage Current Thermocouples RTD100, ...
GEORGIN S.A.
... any query, please contact us by Direct Industry or by email contact@aecl.com.tw Aecl AT-740 JZ, KZ, EZ, TZ, RZ - Thermocouple Converter [Features] ● Cold Junction Compensation. ● Upscale Burnout ...
Please specify:
Help us improve:
remaining