Since ALWA EPF10 is a steel-filled gelcoat, it must be mixed homogeneously before use. For this purpose, the whole container (or depending on the amount several containers) should be heated to about 40 ° C and mixed vigorously until a homogeneous liquid mass is obtained. Now the required quantity in portions of max. 1.5 kg can be weighed. more than 1.5 kg per portion can shorten the pot life. Before adding the hardener, homogenize the mass again. After that, the required amount of hardener can be stirred in carefully. The optimum processing temperature here is between 30 °C – 35 °C. In this temperature range, the pot life is shortened a little, but the material is easy to spread and can be applied to the pattern without inclusion of air. After the hardener has been stirred in, the mass is again transferred to a new container and stirred again. This serves the purpose to leave not well mixed gelcoat on the sides and on the bottom of the cup, since it would not get fully hard. The gelcoat can then be applied with a short-hair brush or a spatula (approx. 2.7 kg/m²). Please note that these steps must be done promptly one after the other, otherwise the filler will sink again and/or the gelcoat will become cold again and cannot be processed well.
If the thickness of the layer should be more than 1 mm, the mixture must be applied several times. Before the second layer can be applied, the first layer must be gelled.