Programming software ProfitTurning®

controlCAMcutting

High-speed rough turning with ProfitTurning, an innovative lathe roughing strategy that helps eliminate the adverse effects of traditional roughing and grooving cycles. ProfitTurning enables manufacturers to make more efficient cuts with consistent chip loads and cutting forces, thereby reducing tool wear, decreasing cycle times, and reducing cost per part up to 60%. This is achieved using an enhanced toolpath algorithm based on an engagement control strategy, which allows for consistent chip load and cutting forces universally and achieves the highest level of productivity. 300% increase in tool life 25% cycle-time reduction Traditional Turning Method Cycle times are longer as machines must run at conservative cutting speeds to account for chip load and acceleration inconsistencies. High radial engagement entry Sharp direction change Advantages of ProfitTurning A high-speed turning cycle allowing increased cutting speeds, resulting in shorter cycle time and longer tool life​. Regular ProfitTurning pass Trochoidal area Roll-in Smooth transitions Trochoidal pass is always connected smoothly Corner picking Alternate cut direction with smooth transitions