Parallel generator set controller DST4602 remote

manual

ST4602Remote is an additional remote display for DST4602Evolution, allowing remote control and configuration. It can also be connected to DST4602 Standard. It shares the same dimensions and look & feel of the main controller (same 7" TFT colour display, same lamps and similar push-buttons). It also allows the same manual operations. DST4602Remote can be connected to the DST4602Evolution by: -RS485 insulated serial port (max 800mt): (only one DST4602Remote is allowed for each DST4602Evolution). -Ethernet(max. distance 100mt without any hub): (up to five DST4602Remote is allowed for each DST4602Evolution). -Remote START/STOP commands for the genset. -Remote OPEN/CLOSE commands for the circuit breakers. -Remote acoustic horn muting. -Remote faults acknowledgment & reset. -Remote parameters configuration. -Local/remote communication settings available from the front panel or by BoardPrg3. Controls Key selector controls -Command disabled: no operation is allowed. -Command enabled: all operations are allowed. -Remote reset: reset of alarms/warnings. Push buttons -REMOTE START: starting is enabled if the operating mode of the local controller is in AUTO. -REMOTE STOP: used to remotely stop the genset. -If the genset has been started by the DST4602Remote, the “REMOTE STOP” stops the genset with the cooling operations. -If the genset has been started by the local DST4602, the “REMOTE STOP” stops the genset immediately without any cooling operations. -GCB :for manual opening/closure of the Genset Circuit Breaker. Security System safety can be increased with a dedicated password