The devices function via the principle of a spring-supported paddle, and the magnetic triggering of a reed switch.
●Soldered/welded connection
●Reed switch
●Low pressure loss
●Compact design
●Threaded connection
●Plug DIN 43650-A / ISO 4400
Handling and Operation
Note
●Include straight calming section of 5 x DN in inlet and outlet
●When tightening the union nut, the connection piece must be countered using an open-ended spanner (SW 19).
●Include a filter if the media are dirty (use magnetic filter for ferritic components).
●It must be ensured that the values given for voltage, current, and power are not exceeded. ●When switched on, a load must be connected in series.
●The electrical details apply to ohmic loads. Capacitive, inductive and lamp loads must be operated using a protective circuit.
Adjustment
To adjust, open the slider. Adjustment is made using the adjustment screw with a lengthways slot; this is located under the valve.
Turn clockwise for a lower switching point; turn anticlockwise for a higher switching point.
After adjustment, close the slider again.
Example: The adjustment range 20 to 27 l/min corresponds to 7 l/min Adjustment option in 7 revolutions. Adjustment is therefore 1 l/min for each revolution.
Options
●Connection for round plug-in connector
●Signal lamp red or red/green in the plug DIN 43650-A
●Protective bellows
●Switching ranges for oil or gas
●Special quantity ●Adhesive PVC fitting