The sensors of the LABO-F012 family are used for monitoring non-viscous fluids (for oil or gases on request). They come complete with electronics, and are supplied installed inside a compact sensor housing of 12 mm diameter and with M12x1 round plug outlet. The 16-bit processor carries outtemperature compensation and linearisation of the calorimetric signal (measurement of the heat removal at the sensor tip by the flowing medium).
The LABO-F012 electronics transmit the result as:
●Analog 0/4...20 mA signal (LABO-F012-I)
●Analog 0/2..10 V signal (LABO-F012-U)
●Frequency signal (LABO-F012-F) or
●Pulse output, pulse / x litres (LABO-F012-C)
A model with switching output is available under designation LABO-F012-S.
If desired, the range end value can be set to the currently existing flow using "teaching".
If the transmitter is ordered in a specific T-piece, it can also be adjusted in l/min. Here, it should be noted that the flow speed is measured at only one point in the tubing cross-section.
●Complete transmitter in 12 mm housing
●For various nominal tubing widths, the same transmitter
●Signal proportional to the flow speed
●4..20 mA or 0..10 V or frequency output
●Adjustable working range
●User-configurable via plug pin (teaching)
●Can be used for various tubing cross-sections
●Very simple to use