Cross & Morse one-way clutches

Torque: 373 Nm - 33,900 Nm
Diameter: 15 mm - 160 mm
Rotational speed: 0 rpm - 3,600 rpm

... each face to enable the fitting of gears, sprockets, pulleys, etc. Four types of clutch are offered MG Series - Standard clutch for general overrunning, backstop and index applications, ...

Torque: 54 Nm - 2,440 Nm
Diameter: 50.8 mm - 114.3 mm
Rotational speed: 300 rpm - 1,800 rpm

... race locating in recess dia. D. The outer race of the clutch is tapped for attaching sprocket, gear or ratchet arm Intended primarily for indexing applications, the clutches can also be used for backstop ...

Torque: 53 Nm - 1,695 Nm
Diameter: 16.5 mm - 56 mm
Rotational speed: 1,800, 2,500, 2,000 rpm

B Series clutches are designed primarily as backstops for gearboxes, but have also been used for indexing in the textile industry. The clutches operate directly on customers' hardened and ground shafts. They consist of ...

Torque: 13 Nm - 35,500 Nm
Rotational speed: 200 rpm - 6,200 rpm

... part by high tensile bolts. The outer race has common dimensions with the AGF series of clutches, and so can when used as a backstop utilise the F4 end flange of this series to provide a fully sealed unit. The fit for ...

Torque: 1.7 Nm - 35,600 Nm
Diameter: 15.8 mm - 420 mm
Rotational speed: 600 rpm - 7,500 rpm

... except for clutch CNAS 6 where transmission is by press-fit onto shaft with n6 tolerance. CNFS Clutches On type CNFS torque transmission from the outer race is via two keys in the end face of the outer race. For good ...

Torque: 2 Nm - 140 Nm
Diameter: 8 mm - 72 mm
Rotational speed: 1,900 rpm - 15,000 rpm

... Carbon Steel profiled Sprags support the compressive loads when the clutch is transmitting torque. Light Retaining End plates attached to the outer race help retain lubricant and protect clutch components ...

Torque: 44 Nm - 56,000 Nm
Diameter: 20 mm - 30 mm
Rotational speed: 200 rpm - 56,000 rpm

... complete unit, with its own lubrication, enabling easy fitting to drive equipment. Roller Ramp Clutch with Ball Bearings AGF/AGFN The AGF Freewheels can be used with special flanges providing these ...

Torque: 0.6 Nm - 240 Nm
Diameter: 16 mm - 95 mm
Rotational speed: 2,200 rpm - 10,000 rpm

... machines, the clutch can be pressed onto shaft to r6 tolerance, with outer driving any steel component with H7 tolerance bore and bearing support. Type ASK - Combined Roller Bearing and Roller Ramp Clutch The ...

Torque: 460 Nm - 18,450 Nm
Diameter: 20 mm - 120 mm
Rotational speed: 130 rpm - 450 rpm

... series of Clutches are specifically designed for backstop applications, for simple fitting to Conveyor and Elevator Headshafts. Their design allows easy installation on new or existing equipment. Backstop ...