Ganter screws

Diameter: 5 mm - 10 mm
Length: 10 mm - 50 mm

... GN 1580 Stainless Steel- Screws and nuts in Hygienic Design are certified according to EHEDG guidelines and are therefore ideal for use in hygienic areas. The sealed mounting surface enables components to be mounted without dead spaces. ...

Length: 12 mm - 40 mm

... instead of a typical tapped and bore hole, it is necessary to provide tapped bores with a thread d1 on each of the two elements to be assembled. Additionally, a clearance bore of d4 on one or both sides ...

Length: 5 mm - 40 mm

... Socket cap screws GN 912.3 have a reduced head diameter compared with socket cap screws ISO 4762. Thus the screws can be countersunk in places where this would not be possible with standard socket ...

Length: 12 mm - 40 mm

... Socket cap screws GN 7984.2 have a low-profile head to enable use in areas with limited space. Due to a recessed stud d3, the screw can be easily secured against loss, for example in a cover. Thus the “captivity of ...

Length: 6, 16, 10, 8 mm

... Socket cap screws GN 7984.3 have a low head height and a reduced head diameter compared with socket cap screws ISO 4762. As a result, these screws can be countersunk in places where this is not possible ...

Length: 6 mm - 16 mm
Batch size: 10 unit

... Socket cap screws GN 14580.5 are used to fasten parts where a counterbore is not possible and insufficient height is available for a normal screw head. Due to their head geometry, screws according ...

Length: 12 mm - 40 mm

... instead of a normal through / threaded hole a thread d1 on both sides, if necessary with a corresponding clearance hole d4 must be provided. Depending on the design and required clamping length a1 ... a3 of the cover, ...

Length: 6 mm - 24 mm

... clamping screws GN 418.3 clamp workpieces by means of eccentric screw heads which, depending on size, are offset by the dimension e in relation to the central axis of the screw shank. The threaded ...