- Robotics - Automation - Industrial IT >
- Automation >
- Receiver >
- IKUSI
IKUSI receivers
... Max. Transmission Rate 95Mbps Full Duplex • Data Transmission up to 2.4Km • PoC Transmission up to 1.2Km • Power Supply Receiver PoE or 12-57V DC • PoE/PoE+ Power Supply for Transmitter • 128 Bit AES Network Encryption • ...
Equipped with integrated external antenna and 1 and a half meter long wiring without final connector (free wires). Ideal for all pocket-sized radio controls for simple handling. Its electronic board is completely resinated to make ...
Sistematica
simpleRTK2B Lite is a standalone board that allows to evaluate dual band RTK GNSS technology. It’s based on u-blox ZED-F9P module and is fully compatible with Pixhawk autopilot and XBee sockets. The product is shipped together with ...
ArduSimple
To locate a pig equipped with a SPY® Transmitter, the SPY® 23 HZ Receive (Pig Tracker Receiver and Wand) registers the changing magnetic field produced by any SPY® Transmitter. When the Transmitter is located, the 23 HZ ...
The TimeSource Enhanced PRTC (ePRTC) is designed to meet the newly consented ITU-T Recommendation G.8272.1 for enhanced Primary Reference Time Clocks and provides a unique solution to help protect telecom and mobile networks against GNSS ...
Microsemi
The USB radio stick is a receiver for the data transferred from the Power-Check 2 device. It is able to receive data from numerous transmitters. Incoming measurements are displayed graphically in real time, saved and exported.
... Remote GPS Receiver provides GPS synchronization for the Doble Model F6150 at the standard GPS frequency (L1 band) of 1575.42 MHz. Thus providing the best timing accuracy for the Model 933A and the Doble Model F6150. ...
8 analogue inputs For use with HS-514 and HS-511 Output - Industrial modbus Wireless (HS-511)
... bluetooth beacons and sends it to external RS485 interface by LLS or MODBUS RTU protocol. Eurosens Dotpoint BT4 receiver Eurosens Dotpoint BT4 receiver Eurosens Dominator COM supports up to 10 sensors ...
... reliable wireless system replacing the requirement for expensive leased lines. The SIL-ECHO-BS (Base Station - Multipoint Receiver) is a low cost driven product, that can be used in Point to Multipoint system (using ...
The receiver model IT3R10 is compatible with the whole range of Itowa radio remote controls. The receiver of small dimensions, is modular and versatile, with internal connector, gland output and multioptions ...
SINDITO - ITOWA
... complete range of receivers, constantly evolving, suitable to be used effectively with its own transmitter. They are all easily and quickly installed, thanks to multi-year experience in design and technology. DIN rail ...
REMdevice
Qingzhun technology full HD video wireless real-time transmission receiver is our latest broadcast-level high-definition image real-time transmission system. Ultra-small (92mmx75mmx30mm), ultra-light (150g), ultra-low ...
Compact and lightweight, the RX MFSHL AC8 offer the simplicity and convenience of quick connect/disconnect. RX MFSHL AC8 offers one (1) Main Contact relay, seven (7) solid state digital outputs and comes in two operating voltage ranges, ...
Hetronic, Inc.
GNSS receiver under development is a high-performance equipment specially designed and optimized for the needs and constraints of small platforms for which small volume, low mass and low power consumption are important ...
RECEIVER 2 OUTPUT Two channels receiver featuring an integrated antenna with 1 or 2 relay output, which can drive an actuator, a pump or directly a burner. Bicolour LED for output relay status and ...
Seitron SpA
... they do, and how to use them. 2 Channel Industrial IoT Long Range Wireless 0-10VDC Receiver Introducing NCD’s Long Range Two Channel Industrial IoT Wireless 0-10V Receiver, boasting up to a 2 Mile range ...
Outdoor receiver with antenna • 2 Channels • 2 operation mode (monostable and bistable) • Compatible with all Leb’s remote controls operating at 433,92 MHz • Far Storing Function Outdoor receiver ...
LEB Electronics Srl
This receiver housing has been specially designed for mobile applications with limited space. Thanks to its compact design, it can also be mounted in places that are difficult to access. Both digital and serial interfaces ...
Signal Converter Types: - Transmitter / Receiver Codes: - Incremental Input/output: - Digital to Fiber Optic / Fiber Optic to Digital
Prexiso G5 The complete, fully integrated GNSS receiver The Prexiso G5 receiver is all you will ever need – a fully featured positioning system. With a range of modern communication devices integrated, ...
... LoadSense HandHeld Receiver Display is used in conjunction with the wireless Load Sensor. It provides the user with an easy way to receive and view data from the Load Sensor. Up to 9 Load Sensors can be selected from ...
Sensor Technology Ltd
The RX_024_004 is an integrated ultra-wide band (UWB) receiver in the 24 GHz frequency range. Its frequency band is between 23 GHz to 29 GHz. It therefore can fully exploit the 24 GHz ISM band. The intrinsic bandwidth ...
... /10 is our entry-level model with relay outputs. The receiver comes in two basic versions, either with 5 or 10 relays. The relay outputs are separated from the rest of the electronics in the receiver ...
Scanreco Group
Digital IR Receivers with 4/8/16/32 Channel Main Features Compliant to IEC 61603-7 and IEC 60914 Compatible with any other IR simultaneous interpretation system compliant to IEC 61603-7 Digital infrared processor ...
Your suggestions for improvement:
Receive updates on this section every two weeks.
Please refer to our Privacy Policy for details on how DirectIndustry processes your personal data.
- Brand list
- Manufacturer account
- Buyer account
- Our services
- Newsletter subscription
- About VirtualExpo Group
Please specify:
Help us improve:
remaining