|
|
|
PWPS Marine offers a full line of gas-turbine engines for a variety of maritime applications. Covering a range from 400 to 40,000 horsepower, our engines power ships from as large as destroyers and cruisers to as small as hydrofoils and private yachts. All products are derived from engine designs and technologies successfully service-proven in Pratt & Whitney's aircraft engines.
|
|
|
Vericor offers marine power solutions up to 6 MW. Our solutions are based upon our TF Series gas turbines and can be configured in single and twin applications. They are military specification compliant and can be employed for continuous or emergency power uses. And most importantly, they are smaller and lighter than diesel engine based solutions with the same advantages as our marine gas turbine propulsion solutions.
|
|
|
|
|
|
Marine power management – PPM-3
Cut your costs – manage your power
The new PPM-3 is a very flexible standard power management system for marine applications. It has been specifically developed for fuel-efficient and reliable operation. Moreover, it is easy to configure and simple to use.
Fuel optimisation
The PPM-3 can be configured to always let your gen-sets run in the best combination at any given load based on their actual nominal powers. This will reduce fuel consumption to a minimum. In addition, the integrated harbour operation function means that the emergency generator is allowed to supply the main switchboard with power. This will save fuel while your ship is docked in the harbour.
Fully redundant
As a fully redundant multi-master system, the PPM can manage a wide range of applications with up to 16 diesel generators, 2 shaft generators, 2 shore connections, 8 bus tie breakers and 1 emergency/harbour generator including bus tie breaker control.
Easy to configure and operate
The new utility software design makes it easy for the user to personalise his application. The event builder feature makes it possible to configure and programme user-defined logic operations. Moreover, additional operator panels can be integrated according to the application requirements. Even complicated systems can be configured within a few minutes using the application tool.
|
|
The OPRA Mobile Generator Set is the best solution in the 2MW electrical power range, offered in a 20 foot size configuration:
- simple
- robust
- high reliability and avialability
- low Total Cost of Ownership
|
|
|
This compact and mobile group is transported everywhere easily thanks to its integrated wheels of transport. Equipped with a Inverter regulation, it delivers very a current of high-quality able to feed any type of apparatus. Its complete preparing ensures a very good sound-proofing. The system "interrupor Eco" manages the setting with the automatic idle of the engine but goes further. It indeed makes it possible to control the driving mode at the request of running. That increases autonomy largely, and reduces even more the noise level. With its tank of 13l, EU30i can function until 20:00. It lays out in addition to electric starting of series. Mobility, comfort of use, great autonomy, quality and power of current, make this group extremely general-purpose. Possibility of parallel connection to double the power available to 6000 W.
|
|
|
The EU Series generators represent the leading edge of portable power technology. Ranging from 1,000 to 6,500 watts, Honda EU Generators super quiet, highly fuel efficient and ideal for recreational and home back-up applications.
|
|
This generator powered by the Honda GX390 engine comes standard with a wheel kit for easy use. It also has the option of electric start for further convenience. Thanks to the Honda OHV commercial grade engine, this generator can produce a maximum of 6500 watts of power and features automatic voltage regulator, auto idle, automatic choke and fuel cut solenoid for operation with the optional remote start kit. In addition this generator has an full frame for protection and 120/240V operation.
The voltage selection switch allows for total generator output to be available through each of the 120 volt outlet for powering electric motors with large starting requirements (Output is limited to the rating of each receptacle). This model is an ideal emergency home power generator when a 1 Hp deep well pump is present.
|
|
|
The EU Series generators represent the leading edge of portable power technology. Ranging from 1,000 to 6,500 watts, Honda EU Generators super quiet, highly fuel efficient and ideal for recreational and home back-up applications.
|
|
EV4010
* 4000 watt 33.3 amp RV generator
* Powerful Honda 12 Hp OHC twin cylinder, liquid-cooled engine
* Engine overheat protection
* 30 amp circuit protection
* Dual element air cleaner
* Protected by Honda Oil Alert®
|
|
EU3000iSA
* 3000 watts (25 A) of Honda inverter 120V AC power
* Super quiet operation - 49 to 58dB(A)
* Eco-Throttle - Runs up to 20 hours on 3.4 gals of fuel
* Convenient electric starting
* Advanced inverter technology provides reliable power to computers and other sensitive equipment
* 12v - 12A DC output
* Protected by Oil Alert®
* Power for RV's including 13,500 BTU AC and basic home backup power
* USDA-qualifed spark arrestor/muffler
|
|
This generator powered by the Honda GX390 engine comes standard with a wheel kit for easy use. It also has the option of electric start for further convenience. Thanks to the Honda OHV commercial grade engine, this generator can produce a maximum of 6500 watts of power and features automatic voltage regulator, auto idle, automatic choke and fuel cut solenoid for operation with the optional remote start kit. In addition this generator has an full frame for protection and 120/240V operation.
The voltage selection switch allows for total generator output to be available through each of the 120 volt outlet for powering electric motors with large starting requirements (Output is limited to the rating of each receptacle). This model is an ideal emergency home power generator when a 1 Hp deep well pump is present.
|
|
DST4601/PX is the evolution of SICES renowned DST4601 AMF controller.
Aimed particularly to parallel application, thanks to its high degree of configuration, it can easily be used in quite all standard and special gen-set applications.
Born to manage the last generation of electronic engine, it supports CAN interface toward quite all most popular engines: J1939 protocol for VOLVO, SCANIA, DEUTZ, PERKINS, CAT, IVECO and MTU protocols for MTU engines.
A large graphic display, with a resolution of 240x128 pixels, allowed to implement a simple to use operator interface that is able, at the same time, to report an huge number of electrical and engine measures and information. Engine troubleshooting now can be made by textual interface (for example all MTU diagnostic codes are translated in plain English text).
|
|
Generator Paralleling Controller – GPC-2
Compact all-in-one control unit designed for applications programmed in a PLC. The GPC-2 contains all necessary functions for protection and control of a synchronous/asynchronous generator along with all necessary galvanically separated 3-phase measuring circuits.
The GPC-2 is intended for land-based applications. It is designed for the following applications (can be combined):
> Stand-alone
> Parallel with other generators
> Parallel with the mains
The GPC-2 can synchronise the generator and after synchronisation carry out all necessary generator control and protective functions. It is well-suited for PLC-controlled systems and the interfacing can be done via binary and analogue I/Os or via (optional) serial communication.
|
|
Generator Paralleling Controller – GPC-2
Compact all-in-one control unit designed for applications programmed in a PLC. The GPC-2 contains all necessary functions for protection and control of a synchronous/asynchronous generator along with all necessary galvanically separated 3-phase measuring circuits.
The GPC-2 is intended for land-based applications. It is designed for the following applications (can be combined):
> Stand-alone
> Parallel with other generators
> Parallel with the mains
The GPC-2 can synchronise the generator and after synchronisation carry out all necessary generator control and protective functions. It is well-suited for PLC-controlled systems and the interfacing can be done via binary and analogue I/Os or via (optional) serial communication.
|
|
VGF48 Power Generation
The VGF48 generator set is designed for standby and continuous power applications. Waukesha's VGF48 is rated at 625-715 kWe at 50 Hz (1500 rpm) and 750-860 kWe at 60 Hz (1800 rpm).
VGF36 Power Generation
The VGF36 generator set is designed for standby and continuous power applications. Waukesha's VGF36 is rated at 475-535 kWe at 50 Hz (1500 rpm) and 560-645 kWe at 60 Hz (1800 rpm).
VGF24 Power Generation
The VGF24 generator set is designed for standby and continuous power applications. Waukesha's VGF24 is rated at 310-355 kWe at 50 Hz (1500 rpm) and 375-425 kWe at 60 Hz (1800 rpm).
VGF18 Power Generation
The VGF18 generator set is designed for standby and continuous power applications. Waukesha's VGF18 is rated at 230-260 kWe at 50 Hz (1500 rpm) and 280-315 kWe at 60 Hz (1800 rpm).
|
|
Dresser-Rand offers a large model selection of Steam Turbine Generator sets from 500kWe to 100 MW for on-site combined cycle cogeneration and simple cycle power production applications.
D-R installations include Oil and Gas, paper, ethanol, ORC, universities, waste-to-energy, food process, sugar, steel, marine, biomass, and other industries utilizing steam for process or energy production.
Design options include:
- Condensing or non-condensing
- Controlled or automatic extraction
- Mixed steam inlet
- Integrated reduction gear
- Electronic control options
|
|
Turbine-Generators - Intelligent Alternative for Power Generation
An Elliott turbine generator set gives its customers with steam systems an intelligent alternative for reliably, efficiently and cost effectively meeting their electrical power needs with on-site generation. Elliott’s steam turbine generator sets match a wide range of customer applications and power requirements. Elliott can provide complete, custom-engineered packages for continuous or stand-by power resulting in an extremely reliable, highly efficient energy solution ranging from 50 kW to 30 MW.
|
|
| ... products without technical information |
| |
|
|
Other generator sets
