|
|
|
The UV bulb is a key component in a UV curing lamp. DYMAX UV curing bulbs are designed to maximize UV curing intensity while minimizing intensity degradation over time, resulting in fewer bulb changes and lower operating costs. The intensity and spectral output of UV curing bulbs determines their ability to cure UV adhesives and UV coatings. Metal halide bulbs come standard in DYMAX UV curing lamps to match the cure chemistry of most DYMAX UV curing adhesives. Refer to the chart below for UV curing bulbs.
|
|
Panacol UV-systems are currently demonstrating their efficiency in the field of UV-curing of UV-adhesives, potting compounds, coating, finish and fluorescence-inspection in various European companies. The product-line of specific UV-lamps permits extensive application possibilities in handicraft to large production plants within the electronics-, optical-,
medical- and automobile industry.
Our product range:
UV-Hand lamps
Hand lamps for on-grid mobil use
UV-Point Source
UV-Point Source for small and point shape areas
UV-LED
Innovative UV-technology: Curing without heating!
UV-Flood lamps
UV-lamp systems for medium til large curing areas
UV-conveyor systems
Conveyor systems with integrated UV-curing lamps
UV-Cabinet
UV-curing in a closed UV curing cabinet
UV-Special UV systems
Customised UV curing systems
Accessories
Light guides, spare bulbs, goggles...
|
|
DELOLUX 04:
Point lamp with light
conductor
High process reliability
Programmable times of open screen enable constant exposure times
|
|
| ... products without technical information |
| |
UV curable Adhesives, UV curable conformal coatings and UV curable encapsulants for electronic materials assembly cure upon exposure to ultraviolet light in seconds. DYMAX solvent-free UV curable adhesives, conformal coatings and encapsulants are ideal for circuit board assembly, flex circuit encapsulation, peelable and water soluble masking, tamper-proofing, potting and strain relief. IPC MIL Spec and UL approved and multiple viscosity grades of these adhesives, conformal coatings, masks and encapsulants are available.
DYMAX UV curable conformal coatings can be applied over the entire PCB surface or discreet areas to provide complete protection from harsh environments or solvents. UV curable Encapsulants protect components on rigid or flexible boards to -40°C. UV curable peelable and water soluble masks are easy to apply and remove, and are designed for manual or fully automated masking of printed circuit boards prior to wave solder or reflow operations. One-part and two-part potting compounds can achieve full cure in seconds and dramatically reduce cycle times and costs. DYMAX UV curable thermally conductive adhesives transfer more heat and bond faster than competitive products.
|
|
Advantages of Vitralit® UV and light curing-adhesives:
Easy handling
Short curing time for higher productivity
Solvent-free, no heat exposure
Long storage at + 5° c
Very good electrical properties
|
|
The UV Light Cure ® resins are one component products that cure in a few seconds under ultraviolet rays. They are intended, for the most part, for the assembly of translucent materials like glass and transparent plastics (PMMA, PC...). On top of their curing speed, the Light Cure® resins are ideal for high production speeds. For the most pari they will give a perfectly transparent jointing, of optical quality, with extreme resistance and excellent protection against Chemicals.
The polymerization takes place in a few minutes to a fraction of a second. AEC adapts the priming of the resins, and thus the timing of the operation and the application to the base. The glues go from liquid to extremely sticky thixotropic.
|
|
|
|
