High pressure nickel plated brass pneumatic push-in fitting
DN 4 - 6, 250 bar | HP series C.matic

HP is a new generation fitting studied to guarantee tightness with pressure ranges, considered so far “out of reach” with the push-in version. The fitting has been created and developped to be used in the Lubrication systems. Thanks to the innovative gripping system of the collet, our HP push-in fitting can stand up to a maximum of 150 bar pressure.

DATA SHEET

Recommended hoses: PA6-6

Recommended hose sizes: ø 4 mm fitting = 4 x 1,5 ; ø 6 mm ftting = 6 x 3

Acceptable hose tolerance: +/– 0,07 mm up to Ø 6 mm

Temperature range: -20°C÷70°C depending on the tubing used and relevant diameter.

Recommended pressure range: Max 250 bar. The max pressure rate achievable can vary depending on the tubing used and on the room temperature. These two factors may in fact lower the tube bursting pressure
Application field: Lubrication installations.