2 component resin mixer-dispenser (static-dynamic mixer)
UNIDOS 300 TX/MP 200 HV Dekumed Kunststoff- und Maschinenvertrieb GmbH & C

2C Meter Mix and Dispense Machine to process thixotropic epoxy-systems out of 200 litres drums, bucket dispenser

Technical Data
* Steel chassis
* Switch cabinet for electronic and pneumatic
* Follower plates 580 mm for 200 litres drum for A- and B-component, joint-less follower plate sealing
* Ceramic coated pumps in special design
* Special hardened gear metering pumps for high pressure application
* Three phase motors for A and B component, frequency controlled
* Pumps and drive motors directly mounted on follower plates
* Bleed plugs for both follower plates
* Bleed taps for bleeding pumps after drum change with manual pump start
* Low level control for drum A + B
* Speed monitoring for pump drives
* Electronic adjustable dispense quantity
* Electronic adjustable dispense rate, max. 20 kg / min
* Pressure lines 250 bar
* Electronic mixing-ratio adjustment
* Mixing block with dynamic and static mixing
* Stainless steel dynamic and static mixing section
* Electronic mixing block motor, speed adjustable
* Purge of mixing section with base component
* Siemens controller
* Dispense pressure monitoring and programmable limit
* Tripod for mixing block and bucket positioner
* All equipment mounted on a steel platform with lockable rollers
* Acoustic and optical alarm after pot-life end and low level of material
* Set of spares for mixing-gun with delivery of the machine