Ultrasonic distance sensor lcs series

4-20 mA0-10 VM12 connector

Ultrasonic sensors in the lcs series in cuboidal housing with lateral sound exit are available in three device variants with three different detection ranges. Highlights Up to 3 pnp switching outputs Automatic synchronisation for simultaneous operation of up to ten sensors in close quarters Basics 2 or 3 switching outputs in pnp variant microsonic Teach-in on pin 5 0.18 mm resolution Temperature compensation 9–30 V operating voltage LinkControl for configuration of sensors from a PC Description The lcs sensors have a block-like plastic housing with four fixation bores, two of which are already equipped with M4 threaded bushings for eased mounting. Two or three LEDs indicate all operating statuses. Via pin 5 at the M12 circular connector, (Com input), the Ics sensors are set (Teach-in): Switched output D1 is set by connecting pin 5 to +UB, while switched output D2 is set by connecting pin 5 to –UB. Also the sensors with analogue output are set via pin 5. The Ics sensors with switched output offer three operating modes: Single switching point Two-way reflective barrier Window mode Teach-in of a single switching point Place object to be detected (1) at the desired distance Apply +UB to pin 5 for about 3 seconds Then apply +UB to pin 5 again for about 1 seconds Teach-in of a two-way reflective barrier with a fixed reflector Apply +UB to pin 5 for about 3 seconds Then apply +UB to pin 5 again for about 10 seconds For configuration of a window Place object at the near edge of the window (1) Apply +UB to pin 5 for about 3 seconds Then move the object to the far edge of the window (2) Then apply +UB to pin 5 again for about 1 seconds