Input voltage: 10 V - 75 V
Output voltage: 0 V - 60 V
Current: 1 mA
The DPM8605 is a programmable buck power supply which converts voltage and current down. It has both a constant voltage - and a constant current mode. With its TTL interface, it is possible to manage any setting comfortably via your PC ...
Joy-It
Input voltage: 10 V - 75 V
Output voltage: 0 V - 60 V
Current: 10 A
The DPM8624 is a programmable buck power supply which converts voltage and current down. It has both a constant voltage - and a constant current mode. With its RS-485 interface, it is possible to manage any setting comfortably via your ...
Joy-It
Input voltage: 230 V
Output voltage: 0 V - 60 V
Power: 0 W - 720 W
With our RD6012-C, you get a programmable laboratory power supply that provides you with DC voltages between 0.01 and 60 volts and DC currents between 0.01 and 12 amps at the voltage output. With the help of the intuitive control panel, ...
Joy-It
Input voltage: 230 V
Output voltage: 21 V
Current: 1 A
Switching source of constant voltage LPV-12, with output voltage 12V is suitable for powering LED strips. High IP67 provides protection against dust and water. Product parameters: - metal case - with cable ends at both input and ...
GETI
- number of input: 1 - number of outputs: 2 - band: TV / SAT (5 - 2500 MHz) - insertion loss: 47 - 1000 MHz - 3.6 dB / 2300 - 2500 MHz - 5.5 dB - decoupling attenuation: dB 20 dB - DC pass on all outputs - grounding screw - F connectors - ...
GETI
Input voltage: 230 V
Output voltage: 12 V
Current: 300 mA
Antenna power supply GETI GAS300 is designed to supply antenna pre-amplifiers, amplifiers and active hubs in small antenna systems requiring 12 V DC voltage. It is equipped with sockets for connecting F connectors, which makes the assembly ...
GETI
Input voltage: 24, 115, 230 V
Current: 5 A - 48 A
Output frequency: 50 Hz - 60 Hz
Dual switchmode power supply 24 / 115 / 230 VAC supply voltage 3.75 kVAC isolation 2 adjustable 5...24 VDC outputs Output: ±5...24 VDC, 10...48 VDC Short-circuit protection Thermal protection against overload Advanced ...
PR ELECTRONICS
Input voltage: 360 V - 500 V
Output voltage: 24 V
Current: 0.3 A - 6 A
The TRETEC 2406 N is a switch mode power supply of the latest generation, which is characterised by its high efficiency and the minimum power loss. It also works with power boost function. The TRETEC N can be operated in a redundant way. ...
J. Schneider Elektrotechnik
Input voltage: 340 V - 550 V
Output voltage: 24 V
Current: 40 A
These single and three-phased primary switched power supplies are manufactured by J. Schneider Power Supplies Inc. The single-phase primary switched power supplies has an input value of 115/230 V AC (97 - 265 V) or input: 230 V AC (195 ...
J. Schneider Elektrotechnik
The DC buffermodule of the C-TEC 90-10 F series uses ultra-capacitors as energy storage. In normal operation these capacitors are charged with an external charging device. In case of an interruption of the supply, the energy of the ultracapacitors ...
J. Schneider Elektrotechnik
GENERAL INFORMATION Type of installation Plug and Socket connector Product configuration Plug and socket junction box Colour Black (Plastic components) - Techno green (Rubber components) Overall dimensions (mm) 58.8 x 39.25 x ...
At 120kW power size, IPERION-120, the fast charging station for automotive applications by BorgWarner, can charge one vehicle at full power, or two vehicles simultaneously at a maximum power of 60kW each. With an output voltage range ...
BorgWarner universal charging stations deliver fast, safe and efficient charge to industrial electric machines of any type. The charging curve can be controlled by the vehicle battery management system (BMS). Multiple interfaces are ...
Current: 500 mA
Output frequency: 50, 60 Hz
Flush-type power supply Power: 16 VA Mounting: snap in
This power controller and analyzer will enable you to monitor and regulate your system's power factor in order to avoid incurring in fines imposed by your power utility provider due to an excessive consumption of reactive energy. Additionally, ...
Input voltage: 90 V - 264 V
Output voltage: 12 V - 48 V
Current: 0.63 A - 7.5 A
● Peak load (1.5 x rated current, Vo=rated for 5 sec) ● Design for BF application ● Convection cooling for Rated power ● No load < 0.3W ● (-A) for no burst sound ● (-H) for home healthcare application ● -40oC to +70oC operating ...
Skynet Electronic
The Sorensen DLM 600W series of programmable power supplies is designed to provide continuously variable output voltage and current for a broad range of applications in a compact 1U (1.75 inches) high, half-rack (8.5 inch) wide chassis. With ...
AMETEK Programmable Power
Input voltage: 80 V - 300 V
Output voltage: 48 V
Power: 850 W
The GR 850 is a singlephase, «hot-pluggable», fancooled rectifier. With its exceptional power density (30 W/in³) it offers optimal solutions for the 1 U‘ shelf DC ST801 and the 2 U’ shelf DC ST802 in the power range from 850W up to 5100W. Features Space ...
Surge Protective Device Monitoring ProSLS is a monitoring device that continuously monitors the leakage current of an SPD, which is the most accurate predictor of an SPD’s life status. Automatic adjustment to all SPD sizes and models Continuously ...
The ENTES Reactive Power Factor Controllers try to fit the power factor of the system, that is the ratio of the active power to the probable power to the user-defined power factor value by supervising the facility's reactive power with ...
ENTES
RGP was designed to give you quick information about your power factor correction system. Thanks to red, yellow and green expressions generated on the wide screen, you can understand the status of your PFC system immediately. Auto ...
ENTES
This product features a wide range of input voltage of 85-264V AC (50-60 Hz) or 110-350V DC. It has an output of 24V DC 1A to 24W, a green LED status notification, an efficient operation, a short circuit overload protection, a thermal ...
ENTES
* TEMPERATURE RANGE：OPERATING 0℃～40℃, STOREAGE -20℃~80℃ * HOLD UP TIME：16mS IN REGULATOIN LIMIT AT 90VAC INPUT VOLTAGE * EFFICIENCY(PER SET)：POWER SUPPLY EFFICIENCY TYPICAL >80% AT 230V, FULL LOAD * OUTPUT PROTECTION: OPP / OVP / SCP ...
Zippy Technology Corp
Stand-Alone Leak Testing Units for Assembled Stacks Benchtop or free-standing frame with integrated mass flow controllers for accurate leak characterization. Includes PC with Greenlight's Emerald™ software for automated control and datalogging.
Multi-purpose test for battery, bulb, fuse and continuity Audible continuity tester via test probes supplied Readings show up on clear scale Automatically turns power on and off Weight: 143g Size (L x W x D) mm: 115 x 67 x 34 Warranty: 12 months
Input voltage: 104 V - 253 V
Output voltage: 0 V - 30 V
Current: 0 A - 5 A
Regulated output voltage: 0-30V Regulated output current: 0-5A Input voltage: 104 ~ 127V AC (60Hz), or 207 ~ 253V AC (50Hz) Line regulation: CV =< 0.01% + 1mV CC =< 0.2% + 1mA Load regulation: CV =< 0.01% + 3mV (I =< 3A) CC =< 0.2% + ...
Input voltage: 104 V - 253 V
Output voltage: 0 V - 50 V
Current: 0 A - 3 A
High-stabilized constant voltage and current Voltage & current can be adjusted from zero to certain value Current restricted protection and short-circuit protection 3 1/2 digit 0.5 inch display Output 0-50VDC, 0-3A
Voltage: 230 V
There are all kinds of energy needs, just as there are all kinds of roofs. That is why we offer individually tailored solar packages – you can choose your own combination of products out of our wide range of high performance solar modules, ...
Voltage: 230 V
Our storage system is the ideal solution for the environmentally-friendly reduction of electricity costs for private houses and ensure a reliable long-term operation and high output. Our scalable and modular storage solution in combination ...
130, 48 & 24V DC The BC-2500 is a Float Battery Charger and Power Supply based on a modular, redundant platform design. It utilizes high availability with uptime architecture. Available in 480W or 400W with hot-swappable Intelligent ...
Eagle Eye Power Solutions
Input voltage: 400 V
Output voltage: 24 V - 1,000 V
Current: 200 A - 1,000 A
D1000 High Precision Bidirectional DC Power Supply is a high precision DC power supply adopting two-stage conversion architecture, featuring high dynamic response, and bidirectional energy flow. Ideal match for E-motor (controller) testing, ...
Hefei Kewell Power System Co., Ltd.
AC/DC fast charging terminal FASTEO, charging up to 4 vehicules at the same time, 4 in 1, on private or pubic spaces. Main characteristics • Installation: ground anchoring • Built-in protection and compact footprint • Integrated ...
Cahors
Energy capacity: 3,440 kWh
Lower Auxiliary power consumption 20% Less Power Consumption Effective Liquid cooling Higher Efficiency Early Detection Real Time Monitoring
Jinko Solar
The Trig-Tek™ 313A Frequency Divider is used to divide a high frequency to a lower frequency with an exact integer division. Product Information The Trig-Tek™ 313A features a wide frequency range at its input and has 1-digit divisor ...
Did you know that even the most modern power networks are not perfect and voltage sags are the most common cause of equipment malfunction in today’s automated industry? The PCS100 AVC-40, built on a proven and dependable converter platform, ...
ABB UPS and power conditioning products
Input voltage: 90 V - 264 V
Output voltage: 12, 5, 3.3 V
Current: 0 A - 100 A
The D1U54P-W-1200-12-HxxPC series are very high efficiency 1200 watt, power factor corrected front end supply with a 12V main output and a 5V or 3.3V (3A) standby. They have active current sharing and up to 8 supplies may be operated ...
Murata Power Solutions
Please specify:
Help us improve:
remaining