Selfholding solenoid
Open frame solenoid with one discreet position maintained without the continuous application of current.
Specifications
Power requirement Pull 55W
Pull-force 20N
Permanentholdingforce (currentless) 35N
Powerrequirement Neutralisation 3.78W
Ratedvoltage 24VDC
Dutycycle% (cycletime30s) 10%
Classofinsulation B (130°C) DIN VDE 0580
Testvoltage EN 60664-1
Surge category III
Degreeofprotection IP00 (IEC 60529)
Electricaltermination 2.8 x 0.8 Tabs DIN 46342-1
Surfacetreatment Solenoid housing zinc plated & trivalent chrome passivated, plunger chemical nickel plated
Plungerweight 0.046kg
Totalweightofsolenoid 0.245kg
Notes
1) Solenoids manufactured and tested according to DIN VDE 0580
2) Forces indicated measured at 20°C ambient and operating
temperature with 90% of its rated voltage, in horizontal position
3) Activate the solenoid
Positive pole of the supply connected to the plus pole of the coil (+)
4) Neutralization by an electrical impuls
Positive pole of the supply connected to the negative pole
of the coil (-)
Attention: Reduced Power
5) Force values for reference only and can differ
±10% as a result of natural dispertion
6) Remanence approx. 10% of permanent-holding-force
7) Special designs are available
8) All specifications subject to change without notice
9) Compliant with RoHS
10) Our „Technical Explanations“ provide information about the use of
solenoids as well as to general installation and safety instructions