- Hydraulics - Pneumatics >
- Valve >
- Control valve >
- Mival
Mival control valves
DN: 3.2, 4, 6 mm
Pressure: -100,000 Pa - 1,000,000 Pa
Temperature: -5 °C - 60 °C
2/3-Port Mechanical Valve with One-touch Fitting VM100F ・Built-in One-touch fitting reduced installation space and less piping work ・Space saving Built-in One-touch fitting Approx. 35% reduction (25.8 mm shorter) ・Lightweight With ...
SMC PNEUMATIC
DN: 100 mm - 400 mm
Pressure: 0.2 bar
VFP/VFPX Butterfly Valves can be fitted beneath hoppers, bins, silos, screw or other type conveyors, or to intercept pneumatic conveying ducts. Due to their special design material residue between valve ...
WAMGROUP S.p.A
DN: 240 mm - 600 mm
... hoppers, or bins, VFF Silo Closure Butterfly Valves are used in all types of building material processing plants where interception of gravity-fed dry materials is required. VFF-type Silo Closure Butterfly Valves ...
WAMGROUP S.p.A
DN: 100 mm - 140 mm
Pressure: 2.5 bar
Temperature: -20 °C - 90 °C
VW Butterfly Valves are the ideal solution for the interception of gravity-fed or pneumatically conveyed dry powders or granules in a variety of bulk solids handling and processing plants. VW Butterfly Valves ...
WAMGROUP S.p.A
Pressure: 0 bar - 350 bar
Temperature: -30 °C - 120 °C
Flow rate: 40 l/min
... rate options Adjustable by allen key or hand screw, optionally sealable (lockwire holes) In the standard version, the valve is zinc-coated for 240 h protection acc. to ISO 9227
ARGO-HYTOS
DN: 4 mm - 23 mm
Pressure: 20, 40 bar
Temperature: -20 °C - 80 °C
Brass ball valves for low and medium pressure are used for opening and closing compressed air, water and city gas. Available in standard series, these ball valves come in a wide range of models: in-line, ...
Parker Legris
DN: 15 mm - 50 mm
Pressure: 7, 10, 25 bar
Temperature: -10 °C - 185 °C
... optical position feedback to pneumatic control and integrated fieldbus interface. Maximum service life and tightness are achieved by the proven self-adjusting v-seal packing gland. The highly integrated system of valve ...
BÜRKERT FLUID CONTROL SYSTEMS
DN: 0.25 in
Pressure: 3 bar - 10 bar
Temperature: -10 °C - 50 °C
... the adjustment needle valve. The piston opens the main valve when the downstream side of the valve reaches approximately 60% of the supply pressure. The ramp up time to reach the switch-over ...
Parker Pneumatic Division Europe
DN: 15 mm
Pressure: 68 bar
Temperature: -20 °C - 200 °C
Introducing the RS PRO general purpose manual ball valve designed for industrial applications. Manual ball valves are used to operate shut off valves which control water ...
DN: 150 mm - 2,200 mm
Pressure: 10 bar - 25 bar
Temperature: -10 °C - 85 °C
Double-offset butterfly valve with epoxy coating. Perfect shut-off in either flow direction. Flanged ends to EN standards, body and valve disc made of nodular cast iron. Main Applications General ...
KSB S.A.S. - France
DN: 20 mm - 150 mm
Pressure: 52 bar
Temperature: -60 °C - 120 °C
... motor operated valves from Danfoss ICV Flexline™ series are quick and simple to handle, install and service due to their low weight and compact design. The valve is designed to regulate the expansion ...
DANFOSS Refrigeration & Air Conditioning
DN: 0 mm - 1.5 mm
Pressure: 0 bar - 34.7 bar
The needle valve is an adjustable orifice, which can be used to control flow rates, mini-cylinders, nozzles, timing circuits, filling heads, bleed vents, and in many other applications. The adjusted flow ...
Beswick Engineering Co, Inc.
DN: 0.28 mm - 1.4 mm
Pressure: 0 psi - 200 psi
... orifice and check valve. The orifice meters flow in the forward direction, while the check valve permits free return flow. This valve is particularly well suited for control ...
Beswick Engineering Co, Inc.
DN: 0 mm - 1.4 mm
Pressure: 0 psi - 200 psi
The Beswick MIL-MV series metering valve contains an adjustable orifice. The orifice meters fluid flow, regardless of flow direction through the valve. The o-ring seals fit to make the valve ...
Beswick Engineering Co, Inc.
DN: 15 mm - 200 mm
Pressure: 16 bar
Temperature: -20 °C - 160 °C
Weir-type diaphragm valve to DIN/EN with flanged ends, threaded socket ends or socket weld ends, in straight-way pattern; shut-off and sealing to atmosphere by supported and confined diaphragm; body with coating or lining, ...
SISTO Armaturen S.A.
DN: 15 mm - 200 mm
Temperature: -20 °C - 140 °C
... position indicator prevents ingress of contaminants. Valve hydraulics without dead volume ensure optimum conditions for high-purity fluids + protection against deposits. Quick identification of valve ...
SISTO Armaturen S.A.
DN: 15 mm - 200 mm
Temperature: -20 °C - 160 °C
Weir-type diaphragm valve to DIN/EN with flanged ends, threaded socket ends or socket weld ends, in straight-way pattern; shut-off and sealing to atmosphere by supported and confined diaphragm; body with coating or lining, ...
SISTO Armaturen S.A.
DN: 40 mm - 100 mm
Pressure: 73, 145, 87, 116 psi
Temperature: 275, 284 °F
Valves / Mixproof Valves The DT4 tank outlet mixproof valve is used for the reliable separation between the tank and servicing pipeline. The DT4 tank outlet is an extension to ...
Waukesha Cherry-Burrell
DN: 1.5 in - 6 in
Pressure: 5 bar
Temperature: 135, 140 °C
The next generation of mixproof valve technology is the result of continued development from both APV and Waukesha Cherry-Burrell process technologies. Used for the reliable separation of dissimilar fluids, the D4 Series ...
Waukesha Cherry-Burrell
DN: 38 mm - 152 mm
Pressure: 10, 6 bar
The W72RS Series Mix Proof Valve features a lower radial seal for minimal spillage of products when opening or closing. Specifications Materials Product Wetted: ASTM 316L (UNS-S31603); (DIN-1.4404) Non-Product: ...
Waukesha Cherry-Burrell
DN: 25 mm - 400 mm
Pressure: 0 bar - 10 bar
Temperature: 220 °C
... precise control of the flow rate through concentric Iris® diaphragms (similar to a camera diaphragm). - Energy-saving and low-noise control valve due to its free centric passage. - ...
DN: 25 mm - 400 mm
Pressure: 0 bar - 10 bar
Temperature: 180 °C
Energy saving valve for the precise and economical control at low loss of pressure of liquids and gases that can be either clean or contain particles. For : Air for aeration in wastewater treatment ...
DN: 1, 2 mm
Pressure: 0 bar - 88 bar
Temperature: -20 °C - 50 °C
The lockable isolation valve 3/2 way of the series AT is used to open the circuit, allowing in this way the air to flow from the entrance (A) D towards the exit (B). When turning the control ...
DN: 80 mm - 400 mm
Pressure: 6 bar - 8 bar
Temperature: 0 °C - 120 °C
• Slide gate valve for solids flow on/off control, mainly used as an automatic valve for loss-in-weight feeder refill • Double acting pneumatic drive
Kubota Brabender Technologie GmbH
DN: 80 mm - 400 mm
Pressure: 6 bar - 8 bar
Temperature: 0 °C - 120 °C
- Slide gate valve for solids flow on/off control, mainly used as an automatic valve for loss-in-weight feeder refill - Double acting pneumatic drive - Readily mounted 5/2 way solenoid ...
Kubota Brabender Technologie GmbH
DN: 80 mm - 400 mm
Pressure: 6 bar - 8 bar
Temperature: 0 °C - 120 °C
• Slide gate valve for solids flow on/off control, mainly used as an automatic valve for loss-in-weight feeder refill • Double acting pneumatic drive
Kubota Brabender Technologie GmbH
DN: 6 mm - 40 mm
Pressure: 1.5 bar
... range of ball valves with a variety of body and seal material combinations with female thread, male thread or flanged connections. The ball valve dimensions conform to the DIN standard (installation ...
WITT-Gasetechnik
DN: 10 mm
Pressure: 0 bar - 40 bar
... range of ball valves with a variety of body and seal material combinations with female thread, male thread or flanged connections. The ball valve dimensions conform to the DIN standard (installation ...
WITT-Gasetechnik
DN: 20 mm - 100 mm
Pressure: 25, 40 bar
... range of ball valves with a variety of body and seal material combinations with female thread, male thread or flanged connections. The ball valve dimensions conform to the DIN standard (installation ...
WITT-Gasetechnik
The AGVB / AGVM control valves are basic and the most versatile type of control valves. Description The CV 3000 Alphaplus range of Top-guided Single-Seated Control ...
DN: 0.063, 0.125 in
Pressure: 0.5 psi - 100 psi
Temperature: 40 °F - 120 °F
Pressure piloted 3 Way Valves apply signal pressure to a diaphragm that is opposed by a spring force. When then pressure signal force is greater than the spring force it reaches its set-point (also called “On” pressure), ...
AIR Logic
DN: 0.063, 0.125 in
Pressure: 0.5 psi - 100 psi
Temperature: 40 °F - 120 °F
... connection available on the exhaust port. When the valve trips, the supply is open to the output port and the exhaust is closed. There is no connection available on the exhaust port. The valve will ...
AIR Logic
DN: 0.625, 0.125 in
Pressure: 22 psi - 116 psi
Temperature: 40 °F - 120 °F
... port is open to the output port. When the valve trips, the supply is shut off and the output port is vented through the exhaust to atmosphere. There is no connection available on the exhaust port. The valve ...
AIR Logic
DN: 0.25, 0.375 in
Pressure: 700 bar
DN: 0.25 in - 2 in
Pressure: 1,200 psi
Temperature: -60 °F - 450 °F
Part Material Body - CF8M or SUS316 Body Cap - CF8M or SUS316 Bail - CF8M or SUS316 Retainer - CF8M or SUS316 Stem - SUS316 Seat - PTFE+15% GF Seal - PTFE Thrust - PTFE Stem Packing - PTFE Stem Gland - SUS304 Stem Nut - SUS304 Handle ...
... amplifier SV 110, the diaphragm pressure regulator MR or the electronic pressure control system C MOVE which in connection with the electronic control valve Move 1250 or Move X controls ...
DN: 155 mm
Pressure: 2 bar - 10 bar
Temperature: -73 °C - 80 °C
Maximator offers various compressed air operated valves (1/4" to 1") as well as check valves for hydrogen refueling systems and generally for use in hydrogen applications. Hydrogen Valves All ...
... Actuated H2-Valve 15V16M071-H2-10HNC Maximator offers various compressed air operated valves (1/4" to 1") as well as check valves for hydrogen refueling systems and generally for ...
SAMPLING COCK FOR WINE TASTE - STAINLESS STEEL 316
DN: 0.5 mm - 0.9 mm
Pressure: 7 bar
Temperature: -10 °C - 50 °C
Kendrion Kuhnke Automation GmbH
DN: 1.2 mm - 1.6 mm
Pressure: 0 bar - 6 bar
Temperature: -10 °C - 50 °C
Kendrion Kuhnke Automation GmbH
DN: 2 mm
Pressure: 0 bar - 12 bar
Temperature: -10 °C - 70 °C
The Poppet Valve is especially constructed to be utilized in control and panel units. Through its hexagonal construction, the valve is able to be used even in minimal spaces. Various ...
Kendrion Kuhnke Automation GmbH
... conditions could make impossible to use any other kind of dispenser. These metering valves are the double checking version of some Double line metering valves. The use of these units is required ...
Dropsa spa
Pressure: 3 bar - 10 bar
This valve has been designed to control lubricant flow (oil and grease). Piston is made of hardened and ground steel. It is driven by a pneumatic cylinder controlled by a 4-way solenoid valve. This ...
Dropsa spa
Pressure: 400 bar
Temperature: -10 °C - 50 °C
The 4/2 electropneumatic valve has been designed to control the supply of lubrication in dual-line systems (system 2). It is capable of operating with NLGI 2 MAX grease at a maximum pressure of 400 bar ...
Dropsa spa
Your suggestions for improvement:
Receive updates on this section every two weeks.
Please refer to our Privacy Policy for details on how DirectIndustry processes your personal data.
- Brand list
- Manufacturer account
- Buyer account
- Our services
- Newsletter subscription
- About VirtualExpo Group
Please specify:
Help us improve:
remaining