Positioning cylinder 6PF series

pneumaticmagnetic pistontie-rod

» In compliance with ISO 15552 standards and with the previous DIN/ISO 6431 - VDMA 24562 standards » Chrome plated steel rod » Protection class IP67 » Minimal sliding speed of 5 mm/sec » Minimal sliding pressure < 0,1 bar » G variant for dusty applications (cement, resin, mud, residues from wood, etc...) » ATEX version available Series 6PF pneumatic actuators are equipped with a potentiometric linear position transducer integrated inside the rod. This type of cylinder allows, along the entire stroke, a constant control of the rod position which is read processing the change of the transducer internal resistance. The pistons have been equipped with a permanent magnet which enables the use of external end-stroke sensors. The dynamic seals are specific for low friction. Thanks to the electrical connection,realized by means of an M12 male electric round connector positioned on the rear head, these cylinders fulfil the standards of IP67 protection class. Series 6PF cylinders comply with the ISO 15552 standards and can be assembled with the entire range of standard accessories. They are available with bores from 50mm to 125mm with standard strokes from 50mm to 500mm with intervals of 50mm. The sturdy design, the flexible installation and the high performance make Series 6PF suitable for use in applications with tensioning cylinders, positioning cylinders and filling, cutting and measuring systems. Fluid - filtered air class 5.4.4 according to ISO 8573-1. If lubricated air is used, it is recommended to use oil ISOVG32. Once applied the lubrication should never be interrupted. Linearity - 0.1% of the stroke Repeatability - 0.03% of the stroke RESOLUTION - Infinite