Controlled braking brake controller DSP 7000 series

Magtrol’s Model DSP7000 High-Speed Programmable. Dynamometer Controller employs state-of-the-art Digital Signal Processing Technology to provide superior motor testing capabilities. Designed for use with any Magtrol Hysteresis, Eddy-Current or Powder Brake Dynamometer, Magtrol In-Line Torque Transducer or auxiliary instrumentation, the DSP7000 can provide complete PC control via IEEE-488 or RS-232 interface. With up to 500 readings per second, the DSP7000 is ideally suited for both the test lab and the production line. Features DSP7001 Single Channel: Low cost and easy to use DSP7002 Dual Channel: Enables the support of two testing instruments with independent or tandem configurations and two fully independent control loops Built-in Alarm System: For power, speed, torque, temperature, air flow, water flow, electrical overload and external inputs High Speed Data Acquisition: Up to 500 torque and speed points per second of both channels with time stamp High Quality, Easy-to-Read Vacuum Fluorescent Readout: Displays torque, speed, power, auxiliary and PID (proportional gain, integral and derivative) values Fast Full-Curve Data Acquisition: Free-run to locked rotor in seconds Speed & Torque Operating Modes: PID settings for exceptional dynamometer control Programmable Digital PID Values: Controlled and stored via M-Test Software or controlled manually Built-in Current-Regulated Supply: For use with Hysteresis Dynamometer or brakes up to 1amp Adjustable Torque Units: English, Metric and SI are standard Digital Filter: Removes undesired noise from torque signals