Cylindrical workpiece clamping chucks
... specifically designed to meet requirements for a low clamping force with high precision. For internal and external holding of cylindrical workpieces. The jaws are moved in and out by ...
Rotational speed: 2,000, 3,000, 2,500, 1,500, 2,250 rpm
... specifically designed for cylindrical grinding machines. Every chuck is filled with oil to guarantee an efficient chuck operation. The sealed design of these chucks has ...
Rotational speed: 1,500, 3,000, 1,000, 2,000 rpm
... applied until all of the chuck’s jaws are sitting flush against the workpiece’s clamping location. The highly sensitive compensation mechanism effortlessly equalizes any workpiece ...
Clamping range: 400 mm
Rotational speed: 900 rpm
... of the end faces may not exceed 0.01 mm. – High run-out accuracy – Stable clamping Clamping system – Hydraulically operated three-jaw indexing chuck – turnable inside chucks – ...
Clamping range: 160 mm - 350 mm
Rotational speed: 800 rpm - 1,800 rpm
INDEXING CHUCK WITH DRAW BAR CLAMPING AND MANUAL INDEXING MADT MADT chucks series are self-centering. Jaws clamping is automatic trough a draw rod and a rear cylinder ...
Clamping range: 168 mm - 350 mm
Rotational speed: 750 rpm - 1,700 rpm
INDEXING CHUCK WITH MANUAL CLAMPING AND INDEXING MADV Chucks series MADV are self-centering. In version MADV jaws clamping is manual thanks to an operating key ...
Your suggestions for improvement:
Receive updates on this section every two weeks.