Economical flow sensors

... One sensor measures the process temperature and the other sensor is heated to a specific temperature above this. As the flow rate increases, heat gets taken away from the heated sensor ...

... additives, chemicals and detergents. The sensor has no moving parts. The flow is monitored electronically - the medium flows unhindered through the stainless steel sensor ...

EGE flow rate sensors for the flow rate detection of 10...100 l/min feature one-piece measuring tubes with an inner diameter of 20 mm from highly resistant stainless steel V4A (1.4571). ...

EGE flow rate sensors for the flow rate detection of 1...10 l/min feature one-piece measuring tubes with an inner diameter of 4...10 mm from highly resistant stainless steel V4A (1.4571). ...

flow-switch for water-based media lower cost alternative to the flow-captor 4120.13 LED display for power and switching status Operating principle: calorimetric Setpoint: factory-set 30 cm/s, ...

flow switch for liquid media 4120.1x - for water and water-based media 4121.1x - for oil and oil-based media Measuring principle: calorimetric (thermal) Measuring range: 0 - 20 cm/s to 0 - 300 cm/s (water), 0 - 30 cm/s ...

flow-switch with additional temperature output in a rugged stainless steel housing (full encapsulation) for monitoring flow and temperature for waterbased media - operating principle: calorimetric ...

FT-110 Series Turbine Flow Sensors are ideal for OEM applications involving low flow liquid monitoring. FT-110 mount in any orientation, have accuracy ±3% of reading and low flow ...

... kits are provided with every 8711 meter to center the sensor in the process line. Specifications AccuracyUp to 0.15% of volumetric flow rate accuracy over 13:1 flow turndowns, 0.25% ...

The clamp-on sensor installation on the outer pipe wall allows for non-invasive, cost-effective, and low maintenance flow measurements using ultrasound technology. For temporary measurements, the mounting ...

... utilizes piezoelectric sensors embedded in an ETFE vane located downstream of the bluff to detect the generated vortices. The frequency measured represents the flow velocity. A flow factor ...