{{product.productLabel}} {{product.model}}
{{#if product.featureValues}}{{product.productPrice.formattedPrice}} {{#if product.productPrice.priceType === "PRICE_RANGE" }} - {{product.productPrice.formattedPriceMax}} {{/if}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
{{product.productLabel}} {{product.model}}
{{#if product.featureValues}}{{product.productPrice.formattedPrice}} {{#if product.productPrice.priceType === "PRICE_RANGE" }} - {{product.productPrice.formattedPriceMax}} {{/if}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
Pressure: 75, 500, 420 bar
Temperature: -40 °C - 80 °C
Flow rate: 30 l/min
... check valve. If the pressure on the consumer side drops below the pressure setting, the idle circulation is interrupted and the oil fed to the consumer again. Shut-off valves or accumulator charging valves ...
Pressure: 30, 700, 55, 60, 500 bar
Temperature: -40 °C - 80 °C
Flow rate: 25, 180 l/min
... Two-stage valves are a type of pressure control valve. They are used in hydraulic systems that are supplied by dual stage pumps, a combination of high-pressure pump and low-pressure pump. The ...
Pressure: 250 bar
Flow rate: 120 l/min
... Priority valves are a type of metering valve. They ensure that particularly critical consumers are always adequately supplied with hydraulic oil. The priority valve type PV divides the pump ...
Pressure: 1.2, 1 bar
... withstand 1.2 bar absolute in either direction allowing the vacuum line above the pump to be vented with the valve closed. The BGV manual valves have a visual indication ...
EDWARDS
DN: 15 mm
Pressure: 4,500,000 Pa
Temperature: -40 °C - 120 °C
... Hermetically sealed 2-port valves for modulating control of chillers and heat pumps. Expansion, hot-gas and suction throttle applications with one type of valve PS45, stainless steel with ...
DN: 20 mm - 500 mm
... The SD-Severe Duty valve is Copes-Vulcans premium severe duty and critical service control valve design. While virtually identical in outward appearance to the Copes-Vulcan legendarily rugged and dependable D-100 valve ...
DN: 40 mm - 600 mm
Pressure: 25 bar
... Hydraulically operated, deep well pump control valve that adds advanced active check valve logic to standard pump systems. The valve branches off the main line and is ...
BERMAD CS Ltd
DN: 38 mm - 102 mm
Pressure: 6.9 bar
Temperature: 80 °C
... Valves / Relief Valves For installation on pump suction lines, the 40CF-AR Air Vent Valve is designed to operate as a CIP return air relief, and operates against either vacuum ...
DN: 65 mm
Pressure: 350, 420, 690, 1,380 bar
Temperature: -54 °C - 204 °C
... setup of a pump load sense control or by additional pressure compensator valve, one for the whole system, in case if the pump is non-adjustable. Operation When de-energized, the hspec10-32xx blocks ...
HYDRAFORCE
DN: 63 mm - 320 mm
Pressure: 4 bar - 7 bar
Temperature: 80, 50, 120 °C
... Well suited as shut-off device for pumps. Key features are easy and fast maintenance and virtually shock-free locking. ...
VAT Vakuumventile AG
Temperature: -45 °C - 260 °C
... KLINGER BALLOSTAR® KHI BALL VALVES Decades of reliability guaranteed KLINGER Ballostar® KHI ball valves will keep up with stricter requirements and are assured to already meet future standards with regard to tensile, ...
DN: 1.5 in - 56 in
Pressure: 0.3 psi - 8 psi
Temperature: -15 °C - 80 °C
... Presssure Sustaining Valve, also known as Back Pressure Valve, or Back Pressure Sustaining Valve, is a valve that maintain required pressure of inlet port by opening only as much as required. What ...
DN: 2 in - 12 in
... Model RPF, Pump control valves substantially reduces surges that occur when a pump starts or stops. Features ◆ Prevent Water Hammer effect. ◆ Equivalence to combination of Pump’s ...
... Bypass valve with pressure regulator valve, can be utilized in applications where the pump is operating constantly. ...
DN: 0.125 in - 0.5 in
... Manual valve for single acting cylinders (bypass knob) 3 way / 2 position Manual valve for single acting cylinders 3 way / 3 position Manual valve ...
DN: 15 mm - 200 mm
Pressure: 0 bar - 50 bar
Temperature: -60 °C - 350 °C
... stepper motor results in a positioning accuracy of ± 0.2% even with a valve stroke of only 6 mm. By means of super-capacitor technology, in the event of a power supply failure, the valve returns to its defined basic position. ...
Flow rate: 10 l/h - 50 l/h
... the centrifugal pump starts up, the pneumatic valve of the valve manifold opens simultaneously. As a result, the shaft seal and bearing are immediately cooled and lubricated, and this is monitored by ...
DN: 50 mm - 600 mm
Pressure: 25 bar
Flow rate: 16 m³/h - 5,400 m³/h
... ELECTROHYDRAULIC ON/OFF VALVE The valve opens fully or shuts off in response to electric signals. The valve is controlled by a solenoid that allows control liquid to flow in the upper chamber in order ...
DN: 50 mm - 600 mm
Pressure: 25 bar
Flow rate: 16 m³/h - 5,400 m³/h
... PUMP CONTROL VALVE The valve isolates pumps from the system during pumps starting and stopping to protect pipe lines and pumps itself. The valve ...
DN: 80 mm - 300 mm
Pressure: 16 bar
Flow rate: 10 m³/h - 1,600 m³/h
... ELECTROHYDRAULIC ON/OFF VALVE The valve opens fully or shuts off in response to electric signals. The valve is controlled by a solenoid that allows control liquid to flow in the upper chamber in order ...
DN: 20 mm
Pressure: 16 bar
Temperature: 5 °C - 110 °C
... ALL-IN-ONE actuator for 3 points without relay or 2 points with relay connection Operating time: 35 sec for 90° rotation – 11Nm ...
DN: 25 mm - 400 mm
Pressure: 0 bar - 10 bar
Temperature: 220 °C
... Energy saving valve for the precise and economical control at low loss of pressure of liquids and gases that can be either clean or contain particles. Applications - Air for aeration in wastewater treatment plant - Gases - Municipal ...
DN: 25 mm - 400 mm
Pressure: 0 bar - 10 bar
Temperature: 180 °C
... Energy saving valve for the precise and economical control at low loss of pressure of liquids and gases that can be either clean or contain particles. For : Air for aeration in wastewater treatment plant Gases Municipal and industrial ...
DN: 0.5 in - 4 in
Pressure: 0 bar - 4 bar
... Hyperr Valves Pvt Ltd is a leading manufacturers, supplier and exporter of Back Pressure Regulating Valve. Our Back Pressure Regulating Valve is engineered to maintain a constant upstream pressure (inlet ...
DN: 0.5 in - 6 in
Pressure: 0 mbar - 500 mbar
... Hyperr Valves Pvt Ltd is a leading manufacturers, supplier and exporter of Back Pressure Regulating Valve. Our Back Pressure Regulating Valve is engineered to maintain a constant upstream pressure (inlet ...
DN: 1 in - 4 in
Pressure: 0 bar - 5 bar
... Hyperr Valves Pvt Ltd is a leading manufacturers, supplier and exporter of Back Pressure Regulating Valve. Our Back Pressure Regulating Valve is engineered to maintain a constant upstream pressure (inlet ...
DN: 50 mm - 1,200 mm
Pressure: 0 bar - 100 bar
Temperature: -40 °C - 850 °C
... extending the valve’s service life. Elimination of internal leakage – The body halves are precisely machined and sealed with an O-ring, preventing any fluid circulation between the two parts. Protected & replaceable seat – Each ...
DN: 15 mm - 100 mm
Pressure: 10 bar
Temperature: 0 °C - 80 °C
... • Competitive ball valve to work in the water treatment sector • PTFE seats and joints in EPDM or FKM • Completely removable • Pressure -PN10 • Step ball T or step L • Available in PVC-U, PVC-C, PP thermoplastic materials • Connector ...
DN: 20 mm - 75 mm
Pressure: 10 bar
Temperature: 0 °C - 100 °C
... • Materials -PVC-U, PP • Together EPDM, FPM • PN10 • Step of the ball in T or L • Hand lever or with pneumatic actuator or with electric motor 230V / 24V • Gluing, soldering or socket connections, with DIN / ANSI flange, threaded ...
DN: 10 mm - 100 mm
Pressure: 16, 10 bar
Temperature: -20 °C - 120 °C
... • Box with limit switches position indication (electromechanical and / or inductive) Advantage • High quality industrial valves • Flexible modular system with a wide range of variants • Reliable material combinations for the safe ...
Pressure: 0 bar - 400 bar
... etc. The By-Pass valve is controlled from the driver’s cab and makes it possible to provide oil to the vehicle’s hydraulic equipment when necessary. .. • Compact design for direct mounting on the pump’s ...
Sunfab Hydraulics
DN: 100 mm - 400 mm
Pressure: 10 bar
Temperature: -30 °C - 200 °C
... Wafer type knife gate valve for installation between flanges, from size DN 250 onwards also available as lug type execution for flanges acc. to EN 1092-1 / PN 10. Two-piece body, bidirectional tight shutoff. Metal guided plate, locked ...
GEFA Processtechnik
DN: 0.375 in - 2 in
Pressure: 0.2 bar - 20 bar
Temperature: -60 °C - 225 °C
... resistant stainless steel provides a solution. The sealed and gas-tight design covers an even wider application range. The valves can be conveniently adjusted or aligned using the external adjustment, which means that perfect alignment ...
Goetze KG
Pressure: 5,000, 3,000 psi
Temperature: 0 °F - 225 °F
... Easily connect between the end of a Quick-test hose and the process connection • Keep fluid or contaminates out of the hand pump, calibrator or nitrogen control device ...
DN: 2 in - 20 in
Pressure: 175, 16, 235, 10, 25 psi
Temperature: 0 °C - 100 °C
... the water pump is still working. When the valve is fully closed, the limit switch installed on the valve will form an electronic interlocking relationship with the pump to cancel the ...
DN: 6.35 mm
Pressure: 250, 160 psi
Temperature: -29 °C - 66 °C
... Optional Pump Controls are available for all Williams pumps to allow for automatic control of the injection rate The Williams PCV-125-AL Pressure Control Valve provides regulated pressure to operate ...
the best suppliers