Eddy current probe PP series
for surface inspectionfor NDT

eddy current probe
eddy current probe
eddy current probe
eddy current probe
Add to favorites
Compare this product


Measured value
eddy current
for surface inspection, for NDT


ETher NDE design and manufacturer all our Eddy Current (ECT) probes in-house and with the ability to design your probes to the exact non-destructive testing (NDT) application - even the 'simple' Pencil Probe becomes specific to you. With the most common Eddy Current (EC) Pencil Probes available 'on-stock', we can promise rapid delivery on these Probes, meaning that hardly any downtime for your inspection job. KEY FEATURES - ABSOLUTE PENCIL PROBES •High frequency surface inspection of ferromagnetic and non- ferrous metals. •Double shielded for use close to material edges and vertical faces (Mass Effect). •build materials include Delrin plastics and neoprene rubber rings and finger scallops for comfortable, "stress free" handling. •Dis-connectable Microdot Connectors for rapid changeovers. •Locking 4-way LEMO connector with INBAL Probes. •INBAL probes feature an internal balance load, simplifying setup and offering the ultimate in signal to noise ratio; permitting smaller defects to be detected. •Standard probe frequencies available, with a wide range of operating frequencies, meaning one probe may be used for a wider range of applications: 200KHZ (50-600KHZ), 500KHZ (150K-1.5MHZ), 2MHZ (650K-6MHZ) 6MHZ (2-18MHZ) •All frequencies (except 6MHZ) available in Standard and fine tip size. •Probes are offered as standard with fixed dims., but can be supplied in many other configurations.


No catalogs are available for this product.

See all of Ether NDE‘s catalogs
*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.