{{product.productLabel}} {{product.model}}
{{#if product.featureValues}}{{product.productPrice.formattedPrice}} {{#if product.productPrice.priceType === "PRICE_RANGE" }} - {{product.productPrice.formattedPriceMax}} {{/if}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
{{product.productLabel}} {{product.model}}
{{#if product.featureValues}}{{product.productPrice.formattedPrice}} {{#if product.productPrice.priceType === "PRICE_RANGE" }} - {{product.productPrice.formattedPriceMax}} {{/if}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
Manual bolt hole probes have coils that are positioned at right angles to the probe’s shaft length. The probes are rotated by hand inside the bolt hole with the fastener removed. Standard ...
Evident - Olympus Scientific Solutions
Spot probes are used for discovering flaws both on and below surfaces. Available in a broad frequency range, their diameters are usually large for accommodating lower frequencies or scanning large areas. Because spot ...
Evident - Olympus Scientific Solutions
Weld probes offer a cost effective method to inspect in-service ferrous welds. The inspection method is a clean, non-hazardous alternative over magnetic particle inspection, which does not require the ...
Evident - Olympus Scientific Solutions
... hard surfaces). Each probe is fully manufactured in-house according to highest possible standards, carefully calibrated in factory (at several reference points) in order to provide maximum trueness. Additionally, all ...
Constant results even when hot The eddy current method can be used without compromise even under extreme conditions: material speeds up to 150 m/s and wire temperatures up to 1,200 °C prove no problem ...
... can offer two types of Conductivity Probes that fit our SigmaCheck Conductivity Meter. We can now offer our standard Conductivity Probe and our 8mm version. APPLICATION: For use with the SigmaCheck-2 ...
Ether NDE
... Features - Options include field or enclosure mounting, small to large shaft measurements and industry safety ratings - Eddy current sensors feature focused measurement areas over air-coil-based sensors
CSI Technologies
The optical oxygen microsensors for eddy covariance enable measurements with 10 Hz sampling rate. The ECO-PSt7 have a tip size of 30 µm, so there is only minimal flow disturbance. They deliver precise on-the-spot measurements. ...
Our Bulletin 1442 Eddy Current Probe Systems include a linear range of 0.25...29 mm (9.8...1142 mils). These systems are suited for shaft vibration, phase/speed reference, and rotor/thrust ...
Please specify:
Help us improve:
remaining