Materials thickness gauge DML 6000

materials thickness gauge
materials thickness gauge
materials thickness gauge
materials thickness gauge
Add to favorites
Compare this product


Other characteristics
online, contactless


The measured values can be taken to the very edge of the material. Depending on the requirements, measurements can be made at stationary points or traversing across the whole production width. Traverse measurement allows measurement of a maximum amount of material and clearly shows any linear deformation of the material. Benefits at a glance •Rapid and early detection of quality fluctuations •Production control •No material has to be added for grinding •Indication of optimisation potentials after production changes •Measuring data for production control Measuring method The Thickness Gauge DML measures the material thickness of solid, soft and humid materials by contactless measuring using laser beams. In terms of the measuring principle, measurement against precision rollers is distinguished from difference measurement. When measuring against precision rollers, the material is scanned only from one side and a roller is on the opposite side corresponding to the zero line. The difference measurement determines the thickness of the material by scanning on both sides and calculating both values. The thickness is calculated by triangulation. A laser beam is sent to the material surface and observed by a camera provided beside it. If the distance to the board changes, the observation angle changes too and consequently also the position of the image in the sensor is different. The distance to the measured value can be calculated based on the position of the image.


*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.