Conductive level switch 501

for waterfor wastewaterstainless steel

SINCE IT IS AN AFFORDABLE AND WELL-FUNCTIONING LEVEL MONITORING SYSTEM, THE ELECTRODE RELAY 501 WITH MJK ELECTRODES IS OFTEN USED AS A SIMPLE WATER-ON-FLOOR DETECTOR. THE SOLUTION COMES WITH A TRANSMITTER THAT CAN BE MOUNTED ON DIN RAILS AND A HOLDER ALLOWING FOUR ELECTRODES. The MJK 501 level control, with electrode management, consists of an electrode holder allowing a total of four electrodes. The electrodes are made of stainless steel and are connected to the amplifier via the electrode holder. The electrode controller can be adjusted to the desired length, and set to either pumping in or pumping out. For many years, MJK has provided products within on/off level control. These products are for both drinking water installations without daily supervision and for wastewater. Our trustworthy product range provides you with accurate measurements and reliable level control - every time. If you want to hear more about our products within level measurement, you are always very welcome to contact our qualified employees. MJK 501 level relay with level electrodes is a very simple pump control that is mostly used as a safety measure. MJK 501 is often used to safeguard against water on the floor. The signal is generated based on the conductivity of the water. If the electrodes detect water, you can either send an alarm or start a pump to protect non-submersible pumps or other valuable electronics. MJK 501 electrode control is a simple and well-functioning system for monitoring levels or detection of water on the floor. Here you see a pump well that should not be flooded.