Hydraulic pressure intensifier D8.753 series

Hydraulic intensifiers convert a hydraulic pressure on the primary side (input) into a higher pressure on the secondary side (output). This enables the use of the comparatively low pressure of machine tool hydraulics to pressurise a hydraulic cylinder with increased pressure. The oil quantity to be transmitted is not important for the intensifiers of this data sheet. Only after oil supply of the hydraulic cylinder in the low-pressure range is affected, the piston of intensification will be activated according to its specification by an external valve control or by an integrated switching function. Important notes The intensification volume of intensifiers is 21 cm³. This is the reason why no hydraulic element, which functions only with high pressure, e.g. hydraulic accumulators with a gas-preload pressure of more than100 bar and an oil absorption exceeding 10 cm³, must be used in the high-pressure range. The intensification volume of 21 cm³ is only used to generate the high-pressure, i.e. the compressibility of the hydraulic oil (1% at a pressure increase of 150 bar) and the increase of volume of the high-pressure hoses (1cm³ per m at a pressure increase of 100 bar) has to be considered. Complete air bleeding of the hydraulic system is very important. The high-pressure part should be controlled by a pressure gauge. The elements 8753 200, -201 and -203 can be equipped with a manifold-mounted pressure switch for machine tool interlock, when using 8753-202 the pressure switch will be integrated in the piping. The switching pressure should be adjusted to 80 % of the secondary pressure.