{{product.productLabel}} {{product.model}}
{{#if product.featureValues}}{{product.productPrice.formattedPrice}} {{#if product.productPrice.priceType === "PRICE_RANGE" }} - {{product.productPrice.formattedPriceMax}} {{/if}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
{{product.productLabel}} {{product.model}}
{{#if product.featureValues}}{{product.productPrice.formattedPrice}} {{#if product.productPrice.priceType === "PRICE_RANGE" }} - {{product.productPrice.formattedPriceMax}} {{/if}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
Temperature: -50 °C - 200 °C
... supply line is connected with the measuring winding with strain relief in a 2, 3 or 4 wire circuit. The temperature is measured along around 2/3 of the sensor length. ...
EPHYMESS GmbH
Temperature: -50 °C - 200 °C
... • Fully shielded design ( sensor and measuring line) • Where space is limited, the grounding and shielded measuring line are positioned opposite (special implementation) • Current load capacity of shielding up to 50A ...
EPHYMESS GmbH
Temperature: -50 °C - 200 °C
... • Rigid construction • High dielectric strength due to mica insulation • Installation heights from approx. 1 mm thickness • As single and double thermometer • Choice of platinum, copper or nickel measuring winding • Resistant ...
EPHYMESS GmbH
Temperature: -50 °C - 200 °C
... • Highly flexible construction with excellent adaptation to slot unevenness • Very low installation heights possible from approx. 1.2 mm thickness • Simple, low-cost setup Description In an NWT-FLEX, an insulated platinum wire is applied ...
EPHYMESS GmbH
Temperature: -50 °C - 200 °C
... allow temperature measurement on almost any surface. They are particularly suitable for measurement in hard-to-access places and on both flat and curved surfaces. The extremely thin design makes it very easy to measure the external temperature ...
EPHYMESS GmbH
Temperature: -65 °C - 200 °C
... • Measuring resistor sealed in epoxy intermediate slider housing (ZS) • Very stable design • For installation directly in the slots of electrical motors/generators • Can be adapted to almost any slot dimensions Description The ...
EPHYMESS GmbH
Temperature: -50 °C - 200 °C
... electrical motors/generators • Can be adapted to almost any slot dimensions Description In this temperature sensor, the basic sensor is connected directly to the feed line and installed in ...
EPHYMESS GmbH
Temperature: -60 °C - 180 °C
... (KS) and sealed. Thanks to the outstanding electrical properties of the carrier material (PESU mould carrier), no further sensor insulation is necessary up to a high voltage strength of 3.5 kV. ...
EPHYMESS GmbH
... another such that a Pt100 signal occurs. The carrier housing has excellent thermal conductivity. Partial sections between the measuring resistors are well recorded in terms of temperature, thus providing almost integral ...
EPHYMESS GmbH
Temperature: -70 °C - 400 °C
... flange. Brass or stainless steel are available as the material for the head. They are often used to monitor the bearing temperature of electric motors, generators or large pumps and are therefore also available in an approved Ex version ...
EPHYMESS GmbH