Strain gauge amplifiers

Voltage: 10 V
Current: 4 mA - 20 mA
Frequency: 1 kHz

... the ideal measuring amplifier for mobile use in industrial environments. Accuracy class: 0.1 Interfaces: RS232; optionally RS485 Degree of protection: IP51 (front) Optimum Results 4.8 kHz carrier ...

Current: 3 mA - 5 mA

The Trig-Tek™ 201AP Charge Amplifier is designed to amplify the outputs from piezoelectric- or mV-type accelerometers, force gauges, microphones, and pressure pickups. The “Charge” output from the pickup, ...

Voltage: 1 mV - 4.5 mV
Current: 4 mA - 20 mA

Housed in an IP50 in-line enclosure, Mantracourt’s In-Line Amplifier (ILA) converts strain gauge or load cell inputs into a high stability 4-20 mA output. Its small design enables ...

Voltage: 10 V

FEATURES - 10kHz bandwidth - 5B compatible - galvanic isolation - for U, I, R, strain gauge measuring bridges, and LVDTs (inductive distance sensors) - 3 switchable filter cut-off ...

Voltage: 0 V - 10 V
Current: 0 mA - 20 mA

... panel mount The EMGZ 321, a left /right strain gauge amplifier, measures the material tension on both sides of the roller independently. Thus it is possible to monitor the load distribution ...

Voltage: 5 mV
Current: 59 mA

Portable strain gauge amplifier and display About the TR150 Strain Gauge Amplifiers The TR150 is a completely portable, precision ...

Our AMPT 2L product is an in-line analogue strain gauge amplifier with offset and gain controlled by microcontroller. It makes work very simple as it allows for: Gain and offset ...

Voltage: 1.25 V - 5 V

SMA miniature strain gage conditioning amplifier is ideal for applications where signal conditioning is needed and space is limited. SMA is designed for the high accuracy strain ...

Voltage: 0 V - 10 V
Current: 4 mA - 20 mA

Applications The amplifiers of X-Sensors are suitable for the universal signal conditioning of strain gauges sensors. They are therefore suitable for amplifying the mV-sensor signal ...

Voltage: 0.5 mV - 10 mV
Current: 4 mA - 20 mA
Frequency: 1,000 Hz

FUTEK's IAA200 Analog Amplifier with Current Output is FUTEK’s brand new general purpose amplifier solution for in-line amplification of any full bridge strain gauge ...

features TDP is a digital measuring amplifier for strain gauges bridge, including a 24 bit acquisition circuit with programmable gain .Through the Profinet I/O interface ...

... SN ratio · Broad frequency response DC to 10 k Hz (913C) Features The DPM-900 Series is a Dynamic Strain Amplifier. The carrier-wave amplifier features highly accurate, excellent ...

Voltage: 5, 10, 20 V

Thanks to its low weight, the strain-gauge amplifier is ideally suited for on-site calibration tasks when used in combination with force / torque transfer units and torque transfer wrenches. ...