Manual press 113 series

stampingrivetingcrimping

Especially for small batches, a manual workstation with mechanical presses is often the most economical solution. To help you achieve your production goals, we have continuously developed the hand lever presses. Do you need a high force at the stroke end for material forming processes? Then SCHMIDT® Toggle Presses are just the right choice. Features * High force at the end of stroke (see diagramm below) * Honed bores and ground rams provide a long service life and a precise guidance Rapid changeover due to the easy and secure adjustment of the working height * Table tops with precision T-slot and precise alignment between the ram and table bores allow for accurate and repeatable set ups which reduces set-up times * The original position of the hand lever can be varied by 360° * Horizontal pull (111 / 113) * Available for left-handed and right-handed use * The return stroke force of the ram can be adapted to different tool weights * Alignment < 0.05 mm between upper and lower tool * No lubrication necessary Options • Series with no additional charge O Additional charge applies 1) Adjustment of the locking position possible on request 2) Stroke shortened by 10 mm for variant at extra cost 3) Weight was determined in hand lever position 45 ° backwards (guide values) with standard stroke (not special stroke) 4) Typical values; can deviate by ± 3 mm due to casting and manufacturing tolerances 5) Stroke adjustable with stop clamp (in the scope of delivery)