EPHYMESS temperature sensors

Temperature: -50 °C - 200 °C

... supply line is connected with the measuring winding with strain relief in a 2, 3 or 4 wire circuit. The temperature is measured along around 2/3 of the sensor length.

Temperature: -50 °C - 200 °C

• Fully shielded design (sensor and measuring line) • Where space is limited, the grounding and shielded measuring line are positioned opposite (special implementation) • Current load capacity of shielding ...

Temperature: -50 °C - 200 °C

• Rigid construction • High dielectric strength due to mica insulation • Installation heights from approx. 1 mm thickness • As single and double thermometer • Choice of platinum, copper or nickel measuring winding ...

Temperature: -50 °C - 200 °C

• Highly flexible construction with excellent adaptation to slot unevenness • Very low installation heights possible from approx. 1.2 mm thickness • Simple, low-cost setup In an NWT-FLEX, an insulated platinum wire is ...

Temperature: -50 °C - 200 °C

... allow temperature measurement on almost any surface. They are particularly suitable for measurement in hard-to-access places and on both flat and curved surfaces. The extremely thin design makes it very easy to measure ...

Temperature: -65 °C - 200 °C

• Measuring resistor sealed in epoxy intermediate slider housing (ZS) • Very stable design • For installation directly in the slots of electrical motors/generators • Can be adapted to almost any slot dimensions The ...

Temperature: -50 °C - 200 °C

... in the slots of electrical motors/generators • Can be adapted to almost any slot dimensions In this temperature sensor, the basic sensor is connected directly to the feed line ...

Temperature: -60 °C - 180 °C

... (KS) and sealed. Thanks to the outstanding electrical properties of the carrier material (PESU mould carrier), no further sensor insulation is necessary up to a high voltage strength of 3.5 kV.

• Multiple chip sensors installed • Active measuring length similar to construction length • Housing from 2 mm thick and 7 mm wide • Standard lengths 100 mm to 1000 mm • With optional shield In ...

Temperature: -70 °C - 260 °C

... flange. Brass or stainless steel are available as the material for the head. They are often used to monitor the bearing temperature of electric motors, generators or large pumps and are therefore also available in an ...