Seneca Fieldbus input modules

ZC-8AI is used to interface analog inputs (Voltage or current, also with bipolar range) with the CANopen system. The module is able to supply all 8 current loops at the same time, this is very useful ...

... serial interface. A 16 bit counter is available on each input, the maximum frequency input is 100 Hz and it is possible to set one input as a fast counter with a maximum frequency of ...

... protocol selectable through dip-switch). It disposes of 32 bit counters (N.8), maximum frequency input is 10 KHz. A 3-way galvanic isolation among Power supply // input // RS485 circuits assures the integrity ...

... -switch. Insulation - 1.500 Vac a 3 vie Accuracy class - 0,01% Status LED - Power supply Error Tx Data Rx Data Input channels - 1 analog channel for reading (and power supply) up to 4 (350 Ω) or 8 (1,000 ...

The Z-8AI is used to interface analog inputs (Voltage or current, also with bipolar range) with Modbus system. The modules is able to supply all 8 current loops at the sameb time, this is very useful ...

... standard output signal. The number of input is 4 and each input is independent from each other. It’s a ModBUS Slave and can be coupled with any ModBUS Master device. A 3-way galvanic isolation among Power ...

... standard output signal. The number of input is 8 and each input is independent from each other. It's a ModBUS Slave and can be coupled with any ModBUS Master device. A 6-way galvanic isolation among Power ...

... with 2,3 or 4 wires. The number of input is 4 and the each input is independent from each other. It’s a CANopen device and can be connected into a CANopen network. A 6-way galvanic isolation among Power ...

... standard output signal. The number of input is 8 and each input is independent from each other. It’s a CANopen deviced and can be connected into a CANopen network. A 6-way galvanic isolation among Power ...