Analog input module Z-SG2

ModbusserialModbus RTU

Z-SG2 is a load cell converter (strain gauge). The measurement carried out with the 4 or 6-wire technique, is available via ModBUS RTU serial protocol or via the analog output. The strain gauge can be directly powered by the instrument. The load cell calibration is managed by EASY SETUP software in the factory calibration or sample weight mode. Z-SG2 is equipped with ESD discharge protection up to 4 kV. Z-SG2 differs from the Z-SG version for advanced functions (piece counter, automatic tare reset, threshold alarm, firmware automatically updatable) and flexible measurement management mode (measurements available both in full and floating-point, measurement stabilized through noise filter, configurable resolution). The configuration is via software, while baud rate and ModBUS address via DIP-switch. Insulation - 1.500 Vac a 3 vie Accuracy class - 0,01% Status LED - Power supply Error Tx Data Rx Data Input channels - 1 analog channel for reading (and power supply) up to 4 (350 Ω) or 8 (1,000 Ω) strain gauge load cells, 4 or 6-wire connection, equivalent impedance 87 Ω 1DI tare calibration or weight threshold Output channels - 1 analog retransmission channel of the net weight in current (0...20, 4...20 mA) or in voltage (0..5, 0..10 V); 1DO tare calibration or weight threshold Advanced features - Tare acquisition Stable weighing signaling via Modbus Tara Silos function Counting function Tare reset function Datalogging on EASY Setup Advanced settings - Analog output with programmable limits Upgradeable firmware I/O independent digital Wide-range settable sampling rate Alarm threshold with programmable hysteresis Fully configurable analog output Configurable resolution