Digital output module Z-D-OUT
Modbus RTUUSBRS485

digital output module
digital output module
Add to favorites
Compare this product


Signal type
Modbus RTU, USB, RS485, Modbus
Number of inputs/outputs
DIN rail
Other characteristics
programmable, slave


The Z-D-OUT (hw.1with micro USB port on the front panel) is used to drive N.5 SPST relays from all of the control systems which are able to communicate with the transmission protocol MODBUS RTU through the RS485 serial interface. The instrument has N.5 SPST relays, capacity resistive loading of 5 A 250Vac, inductive loading of 2 A. The module is ModBUS Slave and can be coupled with any ModBUS Master device. 3-way galvanic isolation among Power supply // output // RS485 circuits assures the integrity of your data. Power Supply: - 10..40 Vdc; 19..28 Vac (50-60 Hz) Outputs: - 5-CH SPST relay, settings NO/NC Safe state: - Settable at start up or in case of communication fault, programmable delay fron 50 to 250 ms Dimensions: - 17,5 x 100 x 112 [mm] Mounting: - 35 mm symmetrical DIN (46277) rail

Other SENECA | Automation Interfaces products

Data Acquisition & Automation Systems

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.