|
|
Multi-purpose coupling unit for CPC 100
CP CU1 is a coupling-unit designated for measurements with the CPC 100 test system on overhead lines and power cables. Typical applications of this world-wide unique system include: Line impedances and k-factors of overhead lines or power cables, Mutual coupling of parallel lines, Coupling of power lines into signal cables,
Ground impedances of large substations, Step and touch voltages.
The test system offered by OMICRON makes use of frequency shift techniques for accurate measurements regardless of electrical interference.
Applications
- Line impedance and residual compensation factor (k-factor) measurements
- Positive and zero sequence impedance measurements of power lines
- Measurement of mutual coupling of parallel lines
- Measurement of ground impedances of large substations
- Step and touch voltage measurements
- Measurement of coupling impedances between power lines and signal cables
|
|
|
IMP57 is a fundamental accessory for verifier and engineer to perform, connected with GSC5x, SIRIUS 89, Macrotest 5035, Genius 5080E or Combitest 2019, the Loop/Line impedance and the prospective short circuit current evaluation on a distribution circuit. The high value of test current generated (max 200A) allows quick and accurate measurement (0,1mOhm resolution) also close to power transformer. IMP57 consists in a practical and strong plastic suitcase, it haven't any display and can be connected by RS-232 to the above meters (called Master) to read the measurement results. With 4-wire measurement method the results aren't affected by test leads and it's no necessary perform any preliminary calibration.
|
|
AutoPoint DT is a fixtureless, gridless flying probe with a unique power-off impedance analysis measurement system. Excellent for Manufacturing Defect Analysis (MDA) testing and Field Return Failures.
Supplied as a Stand Alone System or integrated with the PinPoint II Advanced Diagnostic Test System System
|
|
DEHNcap Test Adapter/Measuring Impedance
* Easy mechanical and electrical adaptation to HR, LR or XC test sockets
* Measuring impedance for maintenance tests of coupling units with suitable µA meter
* 4 mm safety plugs or sockets
* Energised HR plug, insulated
|
|
| ... products without technical information |
| |
AutoPoint DT is a fixtureless, gridless flying probe with a unique power-off impedance analysis measurement system. Excellent for Manufacturing Defect Analysis (MDA) testing and Field Return Failures.
Supplied as a Stand Alone System or integrated with the PinPoint II Advanced Diagnostic Test System System
|
|
| ... products without technical information |
| |
AutoPoint DT is a fixtureless, gridless flying probe with a unique power-off impedance analysis measurement system. Excellent for Manufacturing Defect Analysis (MDA) testing and Field Return Failures.
Supplied as a Stand Alone System or integrated with the PinPoint II Advanced Diagnostic Test System System
|
|
| ... products without technical information |
| |
|
|
