- Hydraulics - Pneumatics >
- Valve >
- Air valve
Air valves
ILN oil-air interlock injection valve High-performance grease injection valve, suitable for injection lubrication of medium and large gear surfaces.
DN: 0.5 in
Pressure: 20.7 bar
Temperature: 149 °C
... actuated trap) valve. This thermostatic actuator senses the fluid temperature and will modulate the valve open to initiate flow if the temperature falls below the valve’s set point. Once ...
DN: 0.5 in
Pressure: 207 bar
Temperature: 149 °C
... Temperature) automatic thermal shutoff valve is used to sense the sample temperature after the sample cooler. Under normal conditions, the valve is wide open so the sample fluid passes through the valve. ...
DN: 0.375, 0.5 in
Pressure: 10 bar
Temperature: 66, 149 °C
... TV/HAT-RA-LP, the reverse acting cooling valve actuator modulates the valve open to allow a flow of cool water through the system. If the cooling water temperature is above the valve’s ...
Pressure: 10 bar
Temperature: -5 °C - 70 °C
... shortage. DATA SHEET Recommended tubings: accûrding to the fitting connected to the valve. Application field: pneumatic installations fed with filtered, lubricated air.
C.Matic S.p.A.
DN: 0.125 in - 0.75 in
Temperature: -10 °C - 70 °C
Flow rate: 310 l/min - 6,300 l/min
This valve can easily vent the circuit in case of an air supply failure. If assembled on the cylinder port, it increases the cylinder speed. DATASHEET Recommended tubings: according to the fitting ...
C.Matic S.p.A.
DN: 0.125, 0.25 in
Pressure: 0 bar - 8 bar
Temperature: 0 °C - 70 °C
... installée! in a pneumatic circuit, the pressure control sets the working pressure of ail the connected components. The pressure adjustment will be thereby kept steatfy for a long time. h can also be used as an economuer ...
C.Matic S.p.A.
DN: 65 mm - 300 mm
Pressure: 0 mbar - 1,600 mbar
Temperature: -15 °C - 60 °C
VMH Safety shut off valves, slow opening and fast closing with hydraulic or pneumatic actuator The VMH type valve is a safety shut off valve for gaseous media operated ...
... lockup valve is open and allows the free flow of compressed air from the positioner to the pneumatic actuator. When the lockup valve loses its signal ...
Pressure: 0 psi - 145 psi
Temperature: -20 °C - 70 °C
1、Exhaust outlet locates over the body, which is convenient to install muffler to decrease noise and pollution; 2、The external force required by direction-change of series of M5B, M5R and M5L is provided by external mechanism, which ...
Airtac Automatic Industrial
DN: 10 mm - 100 mm
Pressure: 6 bar
... for the toughest demands! For energy savers → 40% less compressed air consumption! Air operated Pinch Valves with Internal Thread Connection - VMC Series The ...
DN: 6 mm - 50 mm
Pressure: 25 bar
Temperature: -20 °C - 150 °C
Sealing form 1 - 3 Shape A Connection 1 - 3 BSP cylindrical internal threads Bore L shaped Contact travel 0°; 90° Surface nickel plated Material Brass housing Aluminium handle Brass ball, ...
DN: 10 mm
Flow rate: 0 m³/h - 1 m³/h
PRODUAL NV2 series terminal control valves are mainly used for heating and cooling applications in HVAC automation systems. They contain PRODUAL thermal actuators and inner ISO 7/1 and outer ISO 228/1 thread mountings, ...
DN: 1 in
Pressure: 0.5 bar - 10 bar
Temperature: -10 °C - 150 °C
The SAV10 sanitary air vent is a self-acting valve designed for air venting applications with liquids. The valve closes when filled with liquid product. ...
DN: 8 mm - 20 mm
Pressure: 0 bar - 16 bar
Temperature: 0 °C - 150 °C
... diaphragm sensing, pressure reducing valves are designed for use with clean air, nitrogen, carbon dioxide, oxygen, argon and other gases or liquids compatible with the construction materials and valve ...
DN: 65 mm - 80 mm
Pressure: 0 bar - 16 bar
Temperature: 0 °C - 150 °C
... sanitary pilot operated pressure reducing valves are designed for use with clean air, nitrogen, carbon dioxide, oxygen, argon and other gases or liquids compatible with the construction materials and ...
DN: 6 mm - 12 mm
Pressure: 40, 50, 45 bar
Temperature: 60 °C
designated for control of quick-acting valves – design including or without regulating valve – suitable for single or double acting operating – meets all tests for use in nuclear energetics – medium ...
DN: 0.25 in - 2 in
Pressure: 63 bar
Temperature: -20 °C - 200 °C
... mount directly actuators Characteristics •General industry application. •Blow-out proof stem design. •100% tested with air & water (Open/Close). Specifications •Ends: BSPP threaded acc. to DIN-259.
ABV
DN: 0.25 in - 4 in
Pressure: 63 bar
Temperature: -20 °C - 200 °C
... mount directly actuarors Characteristics •General industry application. •Blow-out proof stem design. •100% tested with air and water (Open/Close). •Anti-static system. Specifications •Tank bottom flange in AISI-316L.
ABV
DN: 0.375 in - 4 in
Pressure: 63 bar
Temperature: -20 °C - 200 °C
... directly actuators Characteristics • General industry application, •Blow-out proof stem design. •100% tested with air and water (Open/Close). •Anti-static system. Specifications Length: DIN 3202 m3. Ends: ...
ABV
Veson valve ltd 3 position pneumatic actuators provide an operation of 0°- 45°- 90°. The intermediate position is achieved by an external mechanical stop of movement on the 2 auxiliary pistons (for spring ...
pneumaticairactuator.com
DN: 0.25 in - 4 in
Pressure: 150 psi
Temperature: 32 °F - 130 °F
... 120°135°180°) and three position actuators. 11. Solenoid valves are easily mounted without any connecting plank. FEATURES: Direct Acting, On-Off Actuator True Union Ball Valve, directional ...
pneumaticairactuator.com
DN: 1.5 in
Pressure: 2.5 bar - 8 bar
Temperature: -40 °C - 180 °C
... Acting type: Double 2. Medium: clean, dry and without corrosive compressed air 4. Working Temperature: Standard Type: -20°C~+80°C 5. Rotate angle: 90°± 5° 6. Solenoid valve voltage: AC220V ...
pneumaticairactuator.com
DN: 2 in
This valve has been designed for an efficient discharge of large air volumes from small water network systems, filters, containers and other devices where trapped air may impair the systems ...
DN: 1 in
This valve has been designed for an efficient discharge of large air volumes from small water network systems, filters, containers and other devices where trapped air may impair the systems ...
DN: 2 in
This valve has been designed for an efficient discharge of large air volumes from small water network systems, filters, containers and other devices where trapped air may impair the systems ...
DN: 2.4, 3.2, 5.6, 7.1 mm
Pressure: 0 bar - 8 bar
Temperature: -10 °C - 909 °C
... control valve »posiflow«, for water / oil, 24 V DC, NC, G 1/4, DN 2.4, Operating pressure difference max. 8 bar For electronic flow control. For all applications where the flow rate of a liquid or gas has to be ...
Automatic drain valve for electro-compressor start (up to 2 HP). It avoids irreparable damages to mono-phase motors.
DN: 15 mm - 50 mm
Pressure: 0 bar - 16 bar
Temperature: -20 °C - 130 °C
... the GAMMA membrane valve allows advantageous membrane support in both end positions. The optimum heat dissipation of the open membrane, which is in contact with the housing, reduces the thermal load. This makes the GAMMA ...
Pressure: 200, 300 bar
Temperature: -20 °C - 65 °C
Key advantages - High pressure brass cylinder valve for Breathing Air service - Permanent gas tight seal - Choc resistant - π marking according TPED directive - Tested according EN ISO 10297
DN: 8 mm - 25 mm
Pressure: 12 bar
Temperature: 0 °C - 60 °C
TECHNICAL FEATURES: Temperature limits: for air from 0°C to +60°C Pressure limits: for air to a maximum of 12 bar SPECIFIC FEATURES: • The AIRY LOCK valve, ...
EFFEBI
DN: 6 mm - 16 mm
Ventilation elements Air valve, pneumatically activated Air Valve
Pressure: 15,000, 10,000 psi
Temperature: -18 °C - 204 °C
... style ball and stem that eliminates the possibility of ,,stem-turnout,, common with other valves designed for similar service. In addition, these specialty ball valves have re-torqueable seat glands that ...
Watts Fluid Air
DN: 100, 150, 125, 200, 160 mm
Description Valve for exhaust air. Designed for wall or ceiling mounting. Bayonet holders connect to socket VRGU, VRGL, or VRGM.
LINDAB
DN: 0.125 in - 0.5 in
Pressure: 35 psi - 130 psi
Temperature: 0 °F - 160 °F
Soft-start valves allow pneumatic components to be pressurized slowly for safety and control. MGV series soft-start valves are available with port sizes from 1/8" NPT to 1/2" NPT and ...
DN: 32 mm
Pressure: 16 bar
Temperature: -10 °C - 180 °C
... durability in steam and aggressive applications • Valves meeting Pressure Equipment Directive 97/23/EC • Mountable in any position • Tight shut-off and Long Service Life • Parker Angle Seat Valves ...
Parker Fluid and climate Controls Europe
DN: 15 mm - 250 mm
Pressure: 23.8 bar - 40 bar
Temperature: -10 °C - 400 °C
... control, flanged connections according to EN1092-1 PN 40 with prominence. Streamlined flow valves, Streamlined flow valves bellows type, Streamlined flow valves bellows type on carbon ...
Mival
Your suggestions for improvement:
Receive updates on this section every two weeks.
Please refer to our Privacy Policy for details on how DirectIndustry processes your personal data.
- Brand list
- Manufacturer account
- Buyer account
- Our services
- Newsletter subscription
- About VirtualExpo Group
Please specify:
Help us improve:
remaining