Process temperature: 0 °C - 50 °C
Process pressure: 0.2 bar - 11 bar
Precision: 0.5, 1, 0.3 %
... 100 (extended turndown ratio on request) Analog & Digital The mass flow meters and controllers of the red-y smart series make use of the latest MEMS technology and ...
Vögtlin Instruments GmbH – Gas Flow Technology
Volumetric flow rate: 0 l/min - 3 l/min
Process temperature: -40 °C - 180 °C
Process pressure: 200 bar
... the robot’s dynamic behavior. The flowmeters have a very high resolution that supports extremely precise flow rate measurement across a very broad measuring range. Technical Data Linearity: ...
Process temperature: -25 °C - 180 °C
Process pressure: 0.6 MPa - 4 MPa
Precision: 0.5 %
... conductivity more than 5 μs/cm and flow range from 0.2 to 15 m/s. An electromagnetic flow meter is a volumetric Flowmeter that measures the flow velocity ...
... On-Board Flow Meter is a compact on-board fuel flow meter developed for our FP series Volumetric Flow Detector. It accepts pulse signal SIG A and SIG ...
Volumetric flow rate: 0 l/min - 500 l/min
Process temperature: -10 °C - 70 °C
Process pressure: 70,000 Pa - 1,500,000 Pa
... before the flow meter. This flow meter can measure and display as little as 1/100 of the maximum flow range. In the past, it was necessary to use ...
Volumetric flow rate: 5 l/min - 80 l/min
Process temperature: -20 °C - 90 °C
Process pressure: 10 bar
... form a Kármán vortex street in the flow. The distance between the individual vortices is constant. The frequency at which the vortices flow past a sensor depends on the flow velocity ...
SIKA
Process temperature: 0 °C - 95 °C
Precision: 1 %
... with lower accuracy) Nominal pressure - PN 16 Ambient temperature - 60 °C Outputs - IO-Link (configurable: Pulse output (up to 10 kHz), Analog output, Binary input/output Display ...
Process temperature: 60 °C
Precision: 1, 1.5 %
5000 series electromagnetic flow meter is a new flow meter that can be used in non-full tubes. It is ideal for water applications or any dirty liquids which is conductive ...
Holykell
Volumetric flow rate: 0.1 m³/h - 18,000 m³/h
Process temperature: -40 °C - 100 °C
Precision: 0.5 %
... (opt.) Output - Analog: passive 4÷20mA, Pulse: open collector Reverse Flow - Instant measure and totalization of reverse flow Flow Cutoff ...
SGM LEKTRA
Volumetric flow rate: 0.2 m³/s - 20 m³/s
Process temperature: -25 °C - 70 °C
Process pressure: 20 bar
Product of Taiwan, Non invasive design, no down time for installation, no pipe cutting, maintenance at any time, significantly reduce installation and maintenance costs. Tube installation-zero tube damage, no blockage, no leakage and ...
Volumetric flow rate: 3.6 l/h - 180 l/h
Process temperature: 0 °C - 105 °C
Process pressure: 0 bar - 10 bar
... Connection Output - Pulse, 0.3 - 2.2 V Coffee Machines Ensures perfect brews by measuring water flow accurately, detecting empty milk reservoirs and optimizing performance. Water Dispenser In ...
Process pressure: 0.2 bar - 11 bar
Precision: 0.3, 0.5, 1 %
Repeatibility: 0.2 %
... gas flow control for industrial scientific OEM applications Ideal for washdown environments MEMS sensor stability-Lifetime no-drift sensor warranty - if drift occurs, instrument will be repaired or ...
Sierra Instruments
Process pressure: 16 bar
Precision: 0.5 %
... of electromagnetic flowmeter display part flow meter and wireless communication module. The wireless communication module is equipped with IOT network card, that is SIM card. Its ...
Kamboda
Volumetric flow rate: 110,000 m³/h
Process temperature: -10 °C - 85 °C
Electromagnetic Flowmeter for Industrial Process Applications RPMag Compact or remote mounting options Pipe diameters from DN10 to DN2000 Measurement range from 0.1-110,000 m3/hr PTFE or rubber linings, 316 stainless ...
LTH Electronics Ltd
Volumetric flow rate: 1 l/h - 200,000 l/h
Process temperature: -20 °C - 65 °C
Process pressure: 15.6 bar - 39.2 bar
The Alia AVF250 flowmeter is commonly used in location that required on-site analog flow indication. The meter accurately measures small volumes / wide ranges of liquids, ...
Process temperature: -10 °C - 60 °C
Precision: 0.2 %
... entire sensor body at equal area, measure and report the average flow rate over the full diameter of the pipe. The specific design of the multi-electrode sensor compensates for variable flow profiles, ...
Process temperature: -40 °C - 80 °C
Precision: 0.5 %
Repeatibility: 0.1 %
Ultrasonic flow meters that use transit-time methods to measure flow. Introduction D118i is an advanced flow meter, which applies our patented ...
Gentos
Volumetric flow rate: 0.1 l/min - 90 l/min
Process temperature: -20 °C - 160 °C
Process pressure: 16, 10 bar
... of the medium to a minimum compared to normal variable area flow meters. Typical applications The variable area flowmeter and switch model DS07 is used for measuring and monitoring ...
PKP PROZESSMESSTECHNIK GMBH
Process temperature: -40 °C - 300 °C
Process pressure: 16 bar - 420 bar
LTD Series General Electron Flowmeter (hereafter call flowmeter), is a precise flowmeter to measure the flow of liquid in the tube. This flowmeter is a patent right product, ...
Shanghai Yinuo Instrument Co., Ltd
Process temperature: 0 °C - 50 °C
Process pressure: 0.45 MPa
Precision: 1, 0.35 %
... may be selected by the customer:±8V-±16V double-end power supply and +14V-+28V single–end power supply; digital or analog signal input and output; SEMI standard mechanical dimensions; ...
Beijing Sevenstar Flow Co., Ltd.
Volumetric flow rate: 20 l/h - 640,000 l/h
Process temperature: 0 °C - 120 °C
Process pressure: 0.1 bar - 11 bar
Magnetic-inductive flow meter VOLUMTEC Construction according to hygienic design standards, all Measurement in both flow directions Adjustability of the illuminated LC-Display Self-monitoring ...
Volumetric flow rate: 20 l/h - 300 l/h
Process temperature: -40 °C - 80 °C
Process pressure: 1.8 bar - 3.4 bar
what is Diesel Flow Meter? The diesel flow meter is a device to measure linear, nonlinear, mass or wide flow rate and volume flow ...
Flowtech Measuring Instruments Pvt. Ltd.
Volumetric flow rate: 0 m³/h - 1,133 m³/h
Process temperature: 150 °F
Process pressure: 100 psi
... PLUS™ FLOW MEASUREMENT FOR GASES AND LIQUIDS The Flo-Tronic Plus™ is based on a standard Flo-Meter™ with or without a manual flow control valve. It provides visual ...
Process temperature: 5 °C - 50 °C
Precision: 1.5, 1 %
... alarm settintg. ・Change of the calibration temperature, etc RS485 communication. Pulse output for totalized flow. Control of flow in the case of needle valve. CE
KOFLOC Corp.
Volumetric flow rate: 1 m³/h - 4 m³/h
Process temperature: 50 °C
Process pressure: 0.3 bar - 16 bar
... starting flow and is permitted for all installation positions. The meter is equipped with an 8-digit glass/copper register (IP68) and a modulator disc. This enables electronic, non-reactive scanning ...
the best suppliers
Please specify:
Help us improve:
remaining