|
|
Air and gas compressors
GRASYS is the official and exclusive supplier to the Russian and CIS market of industrial compressors, making of the German company Bauer Kompressoren. Bauer Kompressoren is one of the world leading manufacturers of medium and high pressure compressors (pressure range of 30–500 bar) used for compression of air, hydrogen, methane, inert gases, such as nitrogen, helium, and other gas mixtures.
Almost any Customer project may be matched with Bauer Kompressoren compressor equipment best fitting for each specific task:
Air compressors
GÀ Series — 25–35 bar;
GB Series — 30–63 bar;
GÅ Series — 64–90 bar;
GI Series — 90–500 bar.
Noble gas compressors (argon, helium, neon, etc.)
GG Series — 90–350 bar.
Nitrogen compressors
GGI Series — 90–500 bar.
Methane, associated and natural gases compressors
GC Series — 90–350 bar.
Compressors are produced in two configurations: vertical and horizontal.
Vertical configuration featuring the compressor-over-engine design is used in compressors with the capacity ranging between 100 and 600 nl/min
Horizontal configuration is used for compressors with the capacity ranging between 600 and 3500 nl/min.
All compressors are balanced and installed on elastic-damper supports eliminating the need for special fixation on foundation. It is sufficient that compressors are placed on an even surface, energized and connected to consumers.
Bauer Kompressoren is the only manufacturer providing industrial compressors with working cylinders surface nitrogenized with the use of gas or plasma coating technique. This helps to avoid replacement of working cylinders over the entire compressors operating life. Reduced wear of compressors final stages is achieved through the use of floating pistons (while piston rod is linked with guide piston, compressive piston moves freely with the elimination of normally present distorting loads). Roller bearings of crankshaft and piston rods are designed so as to provide for a considerable safety factor and over 30000 running time.
These measures along with the careful selection of lubricating oils contribute to the compressors high reliability by continuous service with long interval between scheduled maintenance. The design of compressors cooling systems allow to provide the optimum cylinders thermal conditions and efficient gas cooling in inter-stage heat exchanges.
|
|
Burton Corblin® compressor
Range of performance:
• Inlet volume: 20 000 m3/h (11750 cfm)
• Power: 2500 kW (3400 hp)
• Discharge pressure: 250 bar ( 3600 psi )
High quality reciprocating technology:
• dry (non lube) compressor technology
• controlled lubrication technology matching process requirements and tolerances
• API 618, 4th edition compressor design
• pressure vessels according international codes as applicable
• complete « plug and play » packages integrating control systems, gas regulation equipments, and gas treatment equipments
• design of package going from basic processes as well as most difficult process applications
• customized technical study of your project as soon as initiated
• optimized design based on a wide experience with hundreds of compressor packages operating in production sites from food industry to petrochemical industries, handling light and heavy gases
• combined technology grouping a piston compressor line with diaphragm compressor head at the final stage resulting in extra flow/pressure performance
• easy maintenance mostly handled by the operators themselves
• after sales: Serviceman on site, spare parts, compressor up grade and revamping
|
|
When a reliable supply of quiet compressed air is required, JUN-AIR's oil-lubricated range of compressors is the perfect choice. The noise level is as low as 35 dB(A) - far below the level of normal conversation.
The quiet, vibration-free and reliable compressors have a compact design and are easily mounted at the place of use.
|
|
HAUG PISTON COMPRESSORS FOR OIL-FREE COMPRESSED AIR
HAUG guarantees technically and economically optimal solutions for compressed air supply, with the security of a constant oil-free quality of the compressed air.
Universal ways of operation
Due to the dry-running technology the HAUG piston compressors can be out of operation, without causing any problem compared to lubricated-compressors and screw compressors. Operation in idle run mode is not required.
Universal application for:
· Continuous operation
· Intermittent operation
· Emergency or reserve operation
|
|
A well established range of direct driven oil lubricated and oil free piston compressors, incorporating the very latest materials and technologies, for the most arduous of applications. The M Series are designed to withstand continuous use in heavy-duty industrial environments.
M Series compressors are available with a range of different outputs and package combinations to suit the most exacting of customer requirements. Oil lubricated units are available in three pressure options up to 10 bar g, 15 bar g and 20 bar g, with flows up to 594 l/min. Oil free units deliver air up to 10 bar g and flows up to 568 l/min.(click here for the full range).
The range of standard packages include: oil lubricated or oil free units; bare compressors for OEM applications; free standing base-frame units; integrated packages with vertical or horizontal receivers, dual compressor systems, enclosures for soundproofing.
|
|
JUN-AIR manufactures complete custom design solutions worldwide to suit a wide range of applications, whatever shape or size, it is designed for the individual customer.
More and more customers have individual requirements for their compressed air solutions, low noise and vibration levels are essential for a built-in compressor supplying air to the customers' equipment. JUN-AIR association with major customers in OEM projects lasts from the initial contact, to the design and final installation of the compressor solution.
|
|
|
Quality, reliability and cost effectiveness distinguish this series. These characteristics are proven daily by many customers world-wide under hardest conditions.
|
|
Industrial Duty Reciprocating Air Compressors
Quincy reciprocating compressors are specifically engineered to deliver the high pressure you need at an affordable price. Quincy reciprocating compressors produce up to 175 psig and are rated at a 100 percent duty cycle.
- Available with a gasoline engine, diesel engine or electric ODP single or
three-phase electric motor
- Motor overload protection standard on all electric models
- Low oil shutdown
- Air-cooled aftercooler
- Pneumatic tank drain
- Two-piece connecting rods
- Industrial class bearings
- Loadless auto stop/start
- Cast iron crankcase and cylinders
Visit www.quincycompressor.com/locator.html to find a local Quincy distributor
|
|
Used by almost every airline in the world for filling on-board emergency cylinders. Also used by major diving contractors, emergency medical service companies and mine rescue centers.
This model will pump from high or medium pressure sources and will also function effectively to collect and transfer the gas from partially depleted supply cylinders to "Top Off" other cylinders to maximum pressure.
The basic booster is two-stage, rated for continuous duty compression ratios of over 15:1 intermittent to 40:1
|
|
|
General's LT Series tank mounted, oil lubricated air compressors are integrally mounted on ASME air receivers to offer further ease of installation and versatility. Tank mounted units should always be used when an accelerator is required on the sprinkler system. Multiple dry valves may be supplied from a single tank mounted air compressor when using an AMD-1 UL / FM Approved air maintenance device on each individual system.
|
|
Piston
Our piston air compressors and vacuum pumps are built to withstand the most rugged operating conditions, with corrosion-resistant materials used for critical internal parts. These air compressors and vacuum pumps are available in motor mounted and separate drive versions.
• Oilless design delivers uncontaminated air; pumps stay cleaner and require less servicing
• Exclusive lap joint ring design and stainless steel seal provide optimum efficiency throughout the service life of the pump
• Aluminum pistons, cylinder and cylinder heads ensure excellent corrosion resistance
• Stainless steel valves help maintain maximum pump efficiency by resisting moisture and preventing foreign particles from lodging on valve seats
|
|
Coaxial 8 bar
It have a maximum outlet pressure of 8 bar, are available in three tank sizes and include the following features:
- ON/OFF pressure switch
- Pressure reducer
- Carrying handle (6 litres) and wheels (24 and 50 litres).
|
|
Mini compressor high pressure tri-staged cooled by air, for Oxygen, Helium, Nitrogenizes and other dry gases.
- Pressure of aspiration: 0 to 1,7 bar,
- Max. Pressure repression: 150 bar,
- Flow: 1,74 to 7,5 l/min.
|
|
Sauer Compressors UK offers 2-stage, 3-stage and 4-stage air cooled compressors covers from 40 bar up to 420 bar.
With the WP 4325 and WP 3215 compressor types, the existing Sauer line of air-cooled high-pressure compressors has been enlarged.
The Tornado series consists of the three-stage WP3215 and the four-stage WP 4325. Each of these is available in the "Basic-Version" - a compressor with motor and an optional separate control unit - and in the "Comsilent-Version" - a complete, ready-to-operate system with soundproof canopy.
The "Comsilent-Version" of a modern compressor station. Fully automatic electronic control, noise insulation down to 72dB (A) at a distance of has everything presently required 1m, integrated filter, demistor and condensate collector tank. The width of less than 800mm width allows it to be conveniently brought through any door, the maintenance points are easily accessible through a side maintenance hatch or a front side designed as a door.
Compressors of the Tornado series can naturally also be supplied fitted out for special applications, for example as a gas-tight version for compressing helium, or for use in explosion-protected zones in compliance with ATEX regulations.
|
|
To be able to meet customer’s demands for particularly low-maintenance compressors, Sauer, in conjunction with well-known partners successfully developed a series of 3-stage air-cooled compressors at the beginning of the 1970s.
Through the division of compression into three stages, these designs demonstrate exceptional endurance even under very difficult operating conditions. We have delivered over 4,000 of these compressors to our customers all over the world for a wide range of applications - you too can benefit from our experience.
The performance of our machines3-stage air-cooled compressors is matched only by our customer support: outstanding service you can rely upon at any time. Our business traditions are based on straight dealing, where honesty is always welcome and a handshake still counts.
Our full range stocks mean we can deliver spare parts required immediately – even for earliest generation compressor parts.
|
|
The compact, quiet 12 and 24V DC compressors are suitable for various applications, including advanced control equipment, military vehicles, trams, trains, emergency vehicles, and remote medical equipment.
|
|
Sophisticated use of clean and dry compressed air in laboratories, within the dental and medical industry results in an increasing demand for higher quality oil-less air compressors.
The JUN-AIR models 1000 and 2000 are traditional piston compressors, providing reliable operation and long lifetime.
Additionally JUN-AIR has introduced the compact and robust OF300 series based on the latest technology in material and an innovative principle of compression with few moving parts.
|
|
| ... products without technical information |
| |
|
|
see the results for the following category : 
