- Robotics - Automation - Industrial IT >
- Automation >
- Fiber optic converter
Fiber optic converters
The CAN-CR210/FO is used for the conversion of the CAN signal from copper wire (ISO 11898-2) to fiber optic cables. This provides a complete isolation and protection against EM-influences. For creating ...
... and Fiber Channel. We also supply Media Converter Chassis, the 1U height 12 slots media converter rack mount chassis specially designed for accommodating chassis-based mini Media Converters. Media ...
Fiberroad Technology
... RS-232 to Multi-mode SC or ST Fiber Converter, DB9 Male Connector Industrial RS-232 to Single-mode SC or ST Fiber Converter, DB9 Male Connector Ethernet Direct ...
Ethernet Direct
... RS232/422/485 to serial fiber media converter Easy DIP switch configuration to change serial modes Serial to fiber media converters supports Multi-Mode 5KM Peer-to-Peer ...
Comtrol Corporation
... to 2 km of optical fiber to link to a C37.94 multiplexer. Similarly, connect an SEL-3094 to a noncompliant multiplexer, and use fiber to connect to a new teleprotection device and another ...
The CAPTF33xx-1xx is a media converter module that provides an interface between a twisted pair RJ-11 port and a fiber port, allowing users to connect central-office voice grade signals to distant Plain ...
Nom du compte Lantronix
The STF-401C series Compact Industrial Serial-to-Fiber Media Converter Series provides a solution to extend any RS-232 or RS-422/485 serial device data transmission distance with 100Fx Fiber ...
The PROFIBUS fiber optic converters of the OPTIrep series are used for connecting PROFIBUS segments via fiber optic cables with a distance up to 30 km. ...
The ERIS-100 device is a fibre-optic Ethernet converter with a switch function that enables Ethernet networks to be connected in a point-to-point topology using two devices of the same type or two independent ...
BITSTREAM S.A.
Operating Mode: - 10/100/1000Base-T to Fiber Ethernet Interface: - Shielded RJ-45 Fiber Interface: - SC Connector Std. (LC option) Transmission Distance: - See distance chart System Wavelength: ...
S.I. Tech, Inc.
... EthernetOptical Fiber Supports IEEE 10/100Base-TX ,10/100Mbps FastEthernet Link Loss Forwarding Bi-Directional Link Loss Forwarding for Real Time Far-End Link Fault Alert Bi-Directional Auto Recovery ...
... , can be configed CAN resistor - 120Ω selected by DIP switch Fiber optic channel - 1 fiber-2 CAN, 2 fiber-1 CAN selectable Fiber optic ...
... are available. Selection depends on the fibre type and the length of the fibre optic link that is required. the LTX-5510-850 transmits at 850 nm over multi-mode fibre optic links of up to 500 meters in ...
Scitec Instruments
The Model 10881A Fiber-Optic to Logic Adapter allows transmission of a digital signal over several kilometers and upon receiving, for the conversion to a + 5 V CMOS logic levl output signal. One optical ...
Arbiter Systems
... forwarding technology, the converter can implement data transmission between the two -types of network connection media. It supports transmission in dual-fiber multi-mode, dual-fiber ...
... communications is also enhanced because the fiber optic cable does not radiate any emissions. FiberPlex recommends “T” units for high security applications because they have been TEMPEST tested and approved. ...
FiberPlex Technologies, LLC
... converts an HDMI signal to SDI supplied via an SFP port. By the selection of the SFP you can choose the transport medium, optical fiber or coaxial copper cable. This gives you a great flexibility how ...
... plastic duplex fibers over a distance of up to 80 meters. The converter powers itself from the serial port and so usually requires no additional power supply. nterfaces: RS232 Interface 9-pin SUB-D female, ...
... EIMK Skorpion Media Converter series makes the conversion of an Ethernet copper segment to fiber simple. By operating fullduplex at 100 Mbps provides the highest possible performance on 100 Mbps links. ...
iSC2F The iSC2F is a cost-effective Single Serial Media Converter solution for the conversion between Serial RS-232/RS485/RS422 interfaces over optical fiber. The iSC2F has been designed to be fully compliant ...
... and control to improve the capability to adapt to different software and simplify the control method. Fiber optic MODEM supports several fibre-optic methods between the asynchronous ...
HANGZHOU AOBO TELECOM.,LTD.
VSE 001 External Fibre Optic Module Connects VAMP protection relays and VAMP 321 to a fibre optic loop or a fibre optic star Used with any device which has a RS-232 or TTL serial interface, ...
Fiber optic temperature sensing for semiconductor in etch and deposition applications The Advanced Energy's Luxtron® M-1100 is the latest FluorOptic® thermometry (FOT) converter platform, ...
PoE media converter (PSE) Transmission over 1 multi-mode or single-mode optical fiber by the same module Transmission over 2 multi-mode or single-mode optical fiber ...
Your suggestions for improvement:
Receive updates on this section every two weeks.
Please refer to our Privacy Policy for details on how DirectIndustry processes your personal data.
- Brand list
- Manufacturer account
- Buyer account
- Our services
- Newsletter subscription
- About VirtualExpo Group
Please specify:
Help us improve:
remaining