|
|
The VMP30H is a multipurpose, mini poppet, pneumatic dispensing valve designed for dispensing low to mid-high viscosity fluids, such as silicone dispensing, RTV dispensing, epoxy dispensing, rubber adhesive dispensing, grease dispensing and dispensing of fluids with fillers.
Features
• Designed for low to mid-high viscosity materials
• Stroke adjustment provides shot size control
• Suck-Back eliminates post-dispense "dripping"
• Separated wetted parts reduces maintenance
• Ideal for filled material
|
|
Microvalves
Nominal orifice 2.5 mm
Nominal flow rate at 6 bar 100 Nl/min
Temperature range max +60°C
Working pressure 2 ... 10 bar
Actuating force ~ 6 N
Fluid 50µ filtered, lubricated or non lubricated air
Materials
* Body: aluminium 11S
* Internal parts: brass OT 58
* Seals: NBR
* Springs: stainless steel
|
|
Compact Poppet Valves
GENERAL:
Inline & Stackable Manifold.
Operation: Internal or external piloted, solenoid pilot or pressure
controlled, high flow poppet valve.
Note: External pilot pressure must be equal to or greater than inlet
pressure to insure proper function.
Mounting: Through holes for mounting.
Materials: Anodized aluminum alloy body, and aluminum alloy top plate. Aluminum alloy poppet with bonded Buna-N sealing surface. Elastomers: Nitrile rubber O-rings.
FEATURES:
- Cost effective
- High flow
- Compact design
- Port Pressure Independent
- Robust construction
- Continuous duty rated
- Ease of maintenance and repair
- Non-Lube service
- Leak tight construction (Series CX)
APPLICATIONS:
- Pulp & Paper - Pulp slurries
- Industrial Mineral
- Steel Mills - Pickling slurries
- Vacuum
- Packaging - Food and chemical
- Leak Test
- Power Generation - Cooling water
|
|
The VP300 is a multipurpose, poppet type pneumatic valve designed for dispensing low viscosity to mid-high viscosity materials, such as silicone dispensing, RTV dispensing, epoxy dispensing, rubber adhesive dispensing, grease dispensing and dispensing fluids with fillers.
Features
• Designed for low to mid-high viscosity materials
• Stroke adjustment provides shot size control
• Suck-Back eliminates post-dispense "dripping"
• Separated wetted parts reduces maintenance
• Ideal for filled material
|
|
|
The design of this double valve type is distinguished by two crossflow passages and special valve poppet and spool elements which provide the valve's unique flow characteristics. Two pressure switches are mounted on an adaptor and measure the pressure in the crossflow passages of the main valve. In normal operation the two valve elements move simultaneously and the pressure switches send a matched pair of signals to the control system. If there is a malfunction and the valve elements do not move simultaneously, the pressure switches send an unmatched pair of signals, the control system switches off the valve and prevents any further valve operation. Therefore, the two pressure switches, when correctly connected to the safety circuit, carry out a reliable monitoring function which is in full accordance with the requirements of EN 692.
|
|
| ... products without technical information |
| |
Nominal sizes NG3-Mini, NG4-Mini, NG6 and NG10
Maximum pressures up to 350 bar
Volume flows up to 80 l/min
Electric, pneumatic, hydraulic and
mechanical actuation
Flange -, sandwich - and cartridge construction
Valves operable in both flow directions
|
|
|
|
