- Electricity - Electronics >
- Electronic Component >
- Converter
Converters
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
... solenoid valves Option: Version with heated sample gas inlet for installing the converter upstream of the sample gas cooler (no NO2 loss) Additional version: Thermal converter with quartz-glass reaction ...
Electro-pneumatic signal converters are the link between the control rooms and pneumatic actuators. I/P converters are available with and without booster stage. The I/P converter with ...
Limit frequency 40 kHz, Voltage or current ouptput, Incrementing output (Spacing factor 1 ... 9999), Multi-range power pack, 2-, 3-, 4-wire and NAMUR sensors as well as rotary encoder connectable, Rated voltage: 200 ... 230 V AC ; 100 ...
The HART Loop Converter (HLC) is a single loop solution. Each HLC is able to power and communicate with one HART-field device. It sets the field device into burst mode and converts up to 4 HART-variables into analog output ...
Frequency-proportional current or voltage output High input frequency of up to 60,000 pulses / minute Various configurable monitoring functions Clearly readable, luminous OLED display Wide operating temperature range
Cost-effective protocol converter Protocol conversion HMI and web server Local data base storage, alarm servers, data exchange, reporting, C# scripting IP20 -10 °C to +50 °C Life cycle status - Active Warranty ...
High-performance protocol converter/IIoT gateway/edge controller Protocol conversion Cloud connectivity HMI and web server Local data base storage, alarm servers, data exchange, reporting, C# scripting UL/cUL Class ...
Rugged protocol converter/IIoT gateway/edge controller Protocol conversion Cloud connectivity HMI and web server Local data base storage, alarm servers, data exchange, reporting, C# scripting IP65, UL Type 1 -30 ...
The compact 2-wire transmitter – the link to the PLC and DULCOMETER®. The 2-wire transmitter DMTa converts the following sensor signals into an interference-insensitive 4-20 mA analogue signal: pH, ORP, temperature, chlorine and conductivity. It ...
... IO-Link devices to a Snap Signal IIoT system, or other control systems that use the Modbus RTU protocol. It is an ideal master converter for collecting and transmitting machine data, process parameters, and diagnostic ...
Break free from protocol limitations with S15C in-line converters. S15C converters take various types of signals such as discrete, analog, and others and convert these signals to smart protocols like ...
This compact T-connector brings a non-ISD enabled device into an ISD system. • Connects conventional emergency stop buttons or safe mechanical switch contacts to an ISD chain of devices • Rugged design rated up to IP67 installs easily, ...
Rotork fast response, high flow, compact I/P, E/P, D/P and P/I electro-pneumatic converters have extensive combinations of inputs and outputs, carry standard FM, CSA, ATEX or IECEx agency approvals, and maintain accuracies ...
The AXFA11 magnetic converter has been developed based on Yokogawa's decades long experience in magnetic flowmeters. The AXFA11 continues the tradition of high quality and reliability that has become synonymous with the ...
YOKOGAWA Europe
The VJET Ethernet/RS-485 converter is a compact, plug-in type communication converter that uses the Modbus/TCP protocol for connecting to host devices with Ethernet capability, and uses the Modbus/RTU ...
YOKOGAWA Europe
DC/DC converter with 0.5 A output from Recom | input ranges 4.3 - 65 VDC | outputis 3.3 V | operates in ambient temperature from -40 to +95 °C without derating Product Features Extra wide input range High ...
Elma Electronic AG
DC/DC converter with 2 W from Recom | input ranges 4.5 - 5.5 VDC | output 5 V | operates in ambient temperature from -40 to +100 °C | high isolation version | tape and reel packaging Product Features Operating ...
Elma Electronic AG
DC/DC converter with 150 W from Bel Power Solutions | input ranges 14.4 - 50.4 VDC | output 12 V | operates in temperatures from -40 to +70 °C | provides 10 ms hold up time and built in O-ring FET Product Features ...
Elma Electronic AG
True power converter, measuring equipment for rated & absorbed true power, up to 3 motors/generators, measuring voltage 230 V AC, UB = 24 V DC, width 90 mm. General data Approval - CE UKCA Technical data Electrical ...
-Protocol conversion -HMI and web server -Local data base storage, alarm servers, data exchange, reporting, C# scripting -IP20 -10 °C to +50 °C Features Protocol conversion - Yes HMI web server - Yes Local ...
Beijer Electronics
High-performance protocol converter/IIoT gateway/edge controller -Protocol conversion -Cloud connectivity -HMI and web server -Local data base storage, alarm servers, data exchange, reporting, C# ...
Beijer Electronics
Rugged protocol converter/IIoT gateway/edge controller -Protocol conversion -Cloud connectivity -HMI and web server -Local data base storage, alarm servers, data exchange, reporting, C# scripting ...
Beijer Electronics
The MCP37210-200 is a 12-bit pipelined A/D converter with a maximum sampling rate of 200 Msps. The high accuracy of over 67 dB Signal-to-Noise Ratio (SNR) and 96 dB Spurious Free Dynamic Range (SFDR) enable high precision ...
Microchip Technology Inc.
MCP47CMB22 is a dual channel, 12-bit, buffered voltage output Digital-to-Analog Converter (DAC) with MTP memory and an I²C Compatible Serial Interface. This device provides four different voltage reference options: device ...
Microchip Technology Inc.
The EMC1701 is a combination high-side current sensing device with precision temperature measurement. It measures the voltage developed across an external sense resistor to represent the high-side current of a battery or voltage regulator. ...
Microchip Technology Inc.
DIN rail Mount Electropneumatic Actuator -Input 0…20mA/4…20mA -Input resistance: 200 Ω -Output: 0,2…1 bar, 3…15 psi -Air flow rate: 2,5 m3/h -Feature: linear, direct or inverse -Precision: better than 0,5% ...
Electro-pneumatic converter for field mounting -Input 0… 20mA/4… 20mA -Input resistance: 200 Ω -Output: 0.2… 1 bar, 3… 15 psi -Air flow: 2.5 m3/h -Feature: linear, direct or inverse -Accuracy: ...
The 4K Z-Link fibre optic camera link system from LEMO provides multi-channel system camera-style video and audio connections, and control for studio cameras and camcorders alike over a single hybrid cable using LEMO camera connectors. ...
LEMO
The LEMO Gigabit Ethernet to fibre media converter has been designed to ensure reliable conversion in harsh environments. A pair of media converters enables the conversion of signals from Gigabit Ethernet ...
LEMO
The RACKSHACK™ is a modular conversion system from multiple SMPTE connectors/cables to industry standard fibre optic connectors such as ST/SC. The camera end version of the RACKSHACK™ is a 4U high 19-inch chassis, consisting of individual ...
LEMO
The AD9284 is a dual 8-bit, monolithic sampling, analog-to-digital converter (ADC) that supports simultaneous operation and is optimized for low cost, low power, and ease of use. Each ADC operates at up to a 250 MSPS ...
The AD9172 is a high performance, dual, 16-bit digital-to-analog converter (DAC) that supports DAC sample rates to 12.6 GSPS. The device features an 8-lane, 15 Gbps JESD204B data input port, a high performance, on-chip ...
... -232C port of the SYSMAC series can be changed into RS-422A/485 port. • You can use RS-422A/RS-485 by connecting the converter to built-in RS-232C port of the CS/CJ series and the RS-232C connector of the Serial Communications ...
The Simex SRS-2/4-Z45 Converter Module, primarily employed to link MASTER devices with a RS-232 port to RS-485 bus, generally supports devices which manage Tx switching through RTS signal and devices that do not control ...
Cross sectional converter Series ULW 3 Recording width up to 100 mm Ambient temperature up to 200 °C High resolution Opto High capacity systems Here you will find cross section converters to ...
Ethernet to RS-232/ 422/ 485 Serial Device Dynamic IP Configuration Server / Client Dual Modes Built-in Security Control Remote Reprogramming Lantech LSC-1102B is a full set serial device within two serial ports ...
Lantech Communications Europe GmbH
Gigabit Ethernet 10/100/1000Base-T to 100/1000Base-X Media Converter Compact and Stand-alone Media Converter 9K Bytes Jumbo Frame Size Link Alarm for both of UTP or fiber connection ...
Lantech Communications Europe GmbH
... Media Converter w/ LLF function Build in Link Loss Forwarding Technology DIP switch for Auto negotiation, Speed , Half/ Full Duplex and LLF mode Slide in 16-slot converter chassis Lantech ...
Lantech Communications Europe GmbH
The digital conductivity converter CONDIX4613 is used for the conductivity measurement of liquids. The integrated digital transmitter submits values and parameters to a master (e.g. PLC, SCADA). Device parameters and ...
Senseca Germany GmbH
The digital conductivity converter CONDIX4613 is used for the conductivity measurement of liquids. The integrated digital transmitter submits values and parameters to a master (e.g. PLC, SCADA). Device parameters and ...
Senseca Germany GmbH
The digital conductivity converter CONDIX4623 is used for the conductivity measurement of liquids. The integrated digital transmitter submits values and parameters to a master (e.g. PLC, SCADA). Device parameters and ...
Senseca Germany GmbH
... electrostatic protection and 600W/ms lightning protection -40℃~+85℃ working temperature The MWE820B converter is a USB to RS232/485/422 interface converter that can realize bidirectional data conversion ...
Wuhan Maiwe Communication Co., Ltd
... 30V power input Support working temperature from -40 ℃ to +85 ℃ The MWE485-H4 is a DIN-rail serial port isolation hub converter that supports bidirectional transparent conversion between one RS232/485 master station ...
Wuhan Maiwe Communication Co., Ltd
... The MWE485-TDM is a enhanced 3-end isolation RS232 to RS485/422 interface converter. It can achieve bidirectional data conversion between serial ports, and the converter can automatically detect the ...
Wuhan Maiwe Communication Co., Ltd
... diversity of relay and optocoupler modules that use the practical terminal block format. Our analog transformers and temperature converters are specially designed for applications in the field of process measuring and ...
MURRELEKTRONIK
... diversity of relay and optocoupler modules that use the practical terminal block format. Our analog transformers and temperature converters are specially designed for applications in the field of process measuring and ...
MURRELEKTRONIK
MURRELEKTRONIK
In Northern and Central European installations there are many devices that log consumption, equipped with M-BUS communications protocols or interfaces. These equipments measure cold and hot water consumption, as well steam, gas, electricity, ...
TCP1RS+ is a gateway designed to convert the Ethernet physical environment to RS-485. The unit can be fully customised with the software provided, allowing to configure any parameter related to the Ethernet or serial communications ports.
The OMX 200 model series are digital DIN rail mounted signal converters housed in an enclosure only 12.5 mm wide. The OMX 211PM type is a simple single-channel isolator with a convenient setting of the input and output ...
Orbit Merret s.r.o.
... housing or the free OM Link SW from a PC. You can also use this converter as a splitter into 2 analogue outputs. This device is based on a microprocessor with a 24-bit ∆∑ A/D converter, which guarantees ...
Orbit Merret s.r.o.
... OMX 300 model series are digital DIN rail mounted signal converters housed in an enclosure only 17.5 mm wide. The OMX 311UNI type is a galvanic isolated single-channel universal signal converter. It ...
Orbit Merret s.r.o.
ISF102TF: Industrial Fast Ethernet Media Converter The ISF102TF is a Industrial Fast Ethernet Media Converter that supports IEEE 802.3 and IEEE 802.3u/x with 10/100M full/half-duplex, MDI/MDI-X auto-sensing. ...
ISF102TF-P: Industrial Fast Ethernet Media 30W PoE Converter The ISF102TF-P is a Industrial Fast Ethernet 30W PoE Media Converter that supports 802.3 af/at standard, IEEE 802.3, IEEE 802.3u/x with 10/100M ...
ISG302TS-HPW:Industrial Gigabit 90W PoE Media Converter The ISG302TS-HPW is a Industrial Gigabit 90W PoE Media Converter that supports IEEE802.3af/at/bt PoE standard, IEEE 802.3 and IEEE 802.3u/x with ...
Your suggestions for improvement:
Converters transform electrical signals, changing their form, not their content.
ApplicationsConverters are used in industry to adapt a signal to specific uses or to ensure compatibility between different systems.
TechnologiesElectrical converters carry out conversions between alternating and direct currents (DC/DC, AC/DC, etc.). They can also modify amplitude or frequency. They are designed to induce minimum losses, and often isolate the input from the output.
A/D converters convert analog signals into digital signals, while D/A units do the opposite. There is no energy transfer; only signal value is treated. Precision and speed are the goals. In other cases, conversion consists in changing medium. A converter can, for example, transform an electric line signal to optical fiber or radio-frequency form.
Converters also can change data format and protocol, and create gateways between the Ethernet and field buses or the GSM network. Some converters are multi-protocol. Converters are used in measuring to adapt a sensor's measuring signal to a communication medium. Galvanic isolation is often sought in such cases. Gender converters change (pin) connection fitting configurations.
Receive updates on this section every two weeks.
Please refer to our Privacy Policy for details on how DirectIndustry processes your personal data.
- Brand list
- Manufacturer account
- Buyer account
- Our services
- Newsletter subscription
- About VirtualExpo Group
Please specify:
Help us improve:
remaining