{{product.productLabel}} {{product.model}}
{{#if product.featureValues}}{{product.productPrice.formattedPrice}} {{#if product.productPrice.priceType === "PRICE_RANGE" }} - {{product.productPrice.formattedPriceMax}} {{/if}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
{{product.productLabel}} {{product.model}}
{{#if product.featureValues}}{{product.productPrice.formattedPrice}} {{#if product.productPrice.priceType === "PRICE_RANGE" }} - {{product.productPrice.formattedPriceMax}} {{/if}}
{{#each product.specData:i}}
{{name}}: {{value}}
{{#i!=(product.specData.length-1)}}
{{/end}}
{{/each}}
{{{product.idpText}}}
Voltage: 230, 400 V
Primary current: 100,000, 20,000, 3,000, 12,500, 25,000 A
... The 7P Series consists of Type 1 + 2, Type 1, Type 2 and Type 3 surge arresters. These devices include the following features (according to Type): • Single phase systems or three-phase systems • Replaceable varistor ...
Voltage: 60 V - 600 V
... Surge protection devices (SPDs) provide equipment protection from transient overvoltage events lasting micro-seconds. By limiting the overvoltage to the equipment during these events, costly damage and downtime can be mitigated. The surge ...
Littelfuse
Voltage: 58, 41 V
Primary current: 1 A
... jack 8-Pin jack (female) Port 2: protected, RJ45 jack 8-Pin jack (female) Mounting and grounding - 35 mm DIN rail acc. EN 60725 Interface and material data Housing material / plating - ...
Voltage: 2, 6 kV
Primary current: 26 A
... caused by lightning strikes, electrostatic discharges or power grid switching operations, and are extremely hazardous. Such surges can cause electrical systems to fail, destroy electrical and electronic equipment, or even set entire buildings ...
Siemens Low-voltage – Power distribution
Voltage: 255, 150, 320 V
Primary current: 35,000, 50,000, 25,000 A
... High discharge capacity due to powerful creepage discharge spark gap Maximum system availability due to RADAX Flow follow current limitation With module release button for replacing protection modules without tools Operating state / fault indication ...
DEHN + SÖHNE
Primary current: 20,000, 25,000, 40,000, 50,000, 12,500 A
... series of single pole Type 1/Class I lightning current arresters, able to discharge energy (current) from a direct lightning strike (10/350µs) on an external lightning protection system (LPS) or overhead ...
Mersen - Electrical Power
Voltage: 230 V
Primary current: 50,000 A
Surge protection devices for voltage and signal interference protect electrical and electronic systems against high-power overvoltage caused, for example, by lightning strikes. Versions designed specifically for photovoltaic applications, ...
Voltage: 280 V
Primary current: 50,000 A
... Combination arrestor set, lightning and surge arrestor Type 1+2 to DIN EN 61643-11 (B+C to VDE 0675 part 6). • For lightning protection equipotential bonding to VDE 0185-305 (IEC 62305) • ...
OBO Bettermann
Voltage: 275 V
Primary current: 25,000 A
... Type 1 + 2+3 AC surge protector VG Technology Iimp: 25 kA on 10/350µs impulse In: 25 kA Optimized to TOV No leakage current Monobloc Remote signaling EN 61643-11, IEC 61643-11 Certified Type 1+2+3 DACN1-25CVGS ...
CITEL
Voltage: 120 V - 690 V
Primary current: 0 A - 50,000 A
... li>Type 2 AC multipolar surge protector
The pluggable surge ...
CITEL
Voltage: 1,000 V - 1,200 V
Primary current: 15,000 A - 60,000 A
Open circuit voltage: 6 kV - 6 kV
... the core of the SPD to ensure the safest disconnection available. Devices are
DIN-
rail mountable, compact and fitted with a visual failure indicator for straightforward installation and maintenance.
Key features
- Combined
CITEL
Voltage: 440 V
Primary current: 12,500 A
... The Surge Protective Device (or SPD: generic name for any device that protects against voltage surges) is a recognized and effective solution to the overvoltage problem for any of power or telecom, data, or signal networks. ...
Indelec
Voltage: 440 V
Primary current: 30,000 A
... The Surge Protective Device (or SPD: generic name for any device that protects against voltage surges) is a recognized and effective solution to the overvoltage problem for any of power or telecom, data, or signal networks. ...
Indelec
Voltage: 230 V - 400 V
Primary current: 50,000 A - 150,000 A
Open circuit voltage: 0 kV - 1.5 kV
... The Surge Protective Device (or SPD: generic name for any device that protects against voltage surges) is a recognized and effective solution to the overvoltage problem for any of power or telecom, data, or signal networks. ...
Indelec
Voltage: 24, 30 V
Primary current: 600 mA
... provides two-stage surge protection for floating I/0 two wires signals of measurement and control and safety systems. With width of 6mm, it can be easily fitted into any marshalling cabinets or distribution cabinets. The SPD provides ...
Voltage: 600 V
Primary current: 15,000 A - 30,000 A
... Compact equipment for wind power installations. High discharge capacity via zinc oxide varistors and gas dischargers. With thermal separation device. Visual indication of a fault in the equipment. Remote signalling of protection ...
Voltage: 650 V
Primary current: 10 A
... synchronization. The 4496 product series surge protectors are designed to protect hopf GNSS applications supporting the Global Navigation Satellite Systems (GNSS) GPS, Galileo, GLONASS, BeiDou and IRNSS/NavIC against ...
... LIGHTNING AND SURGE ARRESTER FOR INSTALLATION IN THE DC CIRCUITS OF SOLAR PHOTOVOLTAIC SYSTEMS Protector Type 2 (Class C), indicated for the protection of current circuits in photovoltaic panels. Maximum discharge ...
... LIGHTNING AND SURGE ARRESTER FOR INSTALLATION IN THE DC CIRCUITS OF SOLAR PHOTOVOLTAIC SYSTEMS Protector Type 2 (Class C), indicated for the protection of current circuits in photovoltaic panels. Maximum discharge ...
Voltage: 120 V - 440 V
Primary current: 25,000, 100,000 A
... systems. Can be used in TN-S systems The surge arrester meets the requirements of IEC61643-11 The unit is designed to be used between Zone O and Zone 1 (according to IEC62305-4 definition of Lightning ...
Britec Electric Co., Ltd
Voltage: 275, 320, 150 V
Primary current: 12,500, 25,000 A
... window. Application: To prevent power supply equipment from being damaged by surge and lightning. Use on buildings in applications where there is an external lightning protection system installed, ...
Britec Electric Co., Ltd
Voltage: 150 V - 440 V
Primary current: 20,000, 40,000 A
... normal green, red fault. Remote signaling can select. Patented fast tripping mechanism. It is designed as module and 35mm din rail mounting. Designed and manufactured according to IEC61643 standard. Consisting of ...
Britec Electric Co., Ltd
Voltage: 500 V - 1,000 V
Primary current: 20,000 A - 40,000 A
... The Surge Protection Devices (SPD) protect the photovoltaic system against excess voltage induced by atmospheric discharge (lightening) For the protection of the field side in photovoltaic installations, under direct current upstream ...
Cabur
Voltage: 400 V
Primary current: 25,000 A
... • Tested and certified as a protector Type 1 and 2 according to the standard EN IEC 61643-11. • Suitable for Categories I, II, III, IV according to ITC-BT-23. • Double connection in order to facilitate wiring (limited to 63 A). • Compact multi-pole ...
Aplicaciones Tecnológicas, S.A.
Primary current: 25,000 A
... as electrical equipment the SURGYS G140-F surge arrester is specially designed. It is useful against overvoltages due to industrial operation as well as over voltages due to lightning. This kind of surge ...
SOCOMEC
... TheSSLP-VB Signal surge protector is designed according℃relevantrailway standards.lt is a type Of signal surge protector.lts pefformance complies withthe CRCC testing standard Of the Ministry Of RaiIways.lt ...
Voltage: 230 V
Primary current: 0 A - 40 A
... The ETITEC S C is a surge arrester designed to be used indoors. This product complies with the VDE class C and its protection suits the IEC category II. The potection happens on the subdistribution box, as the second ...
ETI
Voltage: 320, 300, 600, 1,100, 1,500 V
Primary current: 20,000, 5,000, 15,000 A
... Surge protection device type 2 with plug-in cartridge, rated discharge current In (8/20μs) 20kA per pole, 1P+N •Type of product: SPD •Type of system: 230/400VAC •Type / Class: 2 •Number of poles: 1P+N •In [kA]: 20 •Type of mounting: ...
LOVATO ELECTRIC
Voltage: 120, 240, 140, 280 V
Primary current: 0 A - 0.03 A
... protection provided by the DIN rail mounting MA30 units is critical. Ideally suited for protecting panel mounted equipment and typically used in the controls section of a motor control centre (MCC), the MA30 range provides ...
Voltage: 6 V - 33 V
Primary current: 5,000 A
... Signal Surge Protector Siganl (SPD) Signal Lightning Protector is also called Data Signal Surge Protector - DIN- Rail Communication Lightning ...
... as alternatives) against surges due to lightning. Type 1+2 and Type 2 48V DC Surge Protector 48V Surge Protector (48V DC SPD) is designed to protect equipment connected ...
LSP
Voltage: 1,040 V
... Specially designed for PV applications, Bremas Surge Protective Devices (SPD) are suitable for protection against induced overvoltages. Can be fixed to a DIN rail for quick installation, and built ...
BREMAS BETTER SWITCHES
the best suppliers