Water valves

DN: 40 mm - 600 mm
Pressure: 10, 16 bar
Temperature: 50 °C

... Resilient-seated gate valve with bolted cover connection and face-to-face length of Basic Series 15 for sea- water applications. Proven design with innovative improvements, such as plastic sliding caps on the wedge, guarantee ...

DN: 10 mm - 100 mm
Pressure: 25 bar
Temperature: -10 °C - 80 °C

... for water distribution domestic and individual 10 BIS : With 1/4'' plugs on both sides to allow pressure gauge connection Possibility of assembly of compensating spring (except for 4'' size) to obtain settings at 0.5 bar Setting ...

DN: 100 mm - 2,000 mm
Pressure: 10 bar - 40 bar
Temperature: 80 °C

... Body material Ductile iron Disc material Ductile iron PN (End) PN40 End Flanged Contact sealing EPDM Operating system Manual gear box ...

DN: 1 in - 10 in

... Desuperheating) are done in a single valve making it an extremely efficient, cost effective and compact solution. Features - Compact Design - High turndown (40:1) - Reduced noise level - Efficient cooling water ...

Pressure: 4 bar - 6 bar

... Jet Edge’s patented Dual Pressure Valve is a remotely mounted valve that allows waterjet operators to control water pressure independently of the intensifier pump. This enables operators ...

DN: 8, 12, 10, 6 mm
Pressure: 4, 10 bar

... resistance than the push-fit acetal valve and is suitable for potable water (10 bar at 20°C), intermittent hot water (4 bar at 60°C), water treatment and purification applications. All ...

DN: 20 mm - 100 mm
Pressure: 3.5 bar - 6 bar
Temperature: 150 °C

... the requirements of the tanks in the Pharmaceutical, Food & Beverage, Cosmetics, Dairy and Fine Chemicals industries. Our valves are suitable for direct installation on the bottom of tanks and preparation reactors for product discharge, ...

DN: 1 mm
Pressure: -70,000 Pa - 200,000 Pa
Temperature: 5 °C - 80 °C

... volume inside the solenoid valve; Multiple options for wetted part material: Diaphragm material: FFKM, EPDM Valve body material: PEEK Long lifetime and high performance. Small volume. Applicable media - ...

DN: 0.5 in - 3 in

... size and is ideal in hot/chilled water units such as, fan coil units, water source heat pumps, reheat coils, panel coils, small branch lines, unit heaters, unit ventilators, finned radiation, small domestic hot ...

DN: 0.75 in
Pressure: 0 bar - 138 bar
Temperature: 0 °C - 200 °C

... replacement valve with Brooks® purge meters. The Cartridge III Valve is a multipurpose valve, designed for use with Brooks® purge meters in gas and liquid flow applications. It is ...

... Cameron's DBA multistage choke is a multiple-pressure drop, anticavitation valve ideally suited for water injection. It controls the problems of cavitation, excessive noise, and vibration. To optimize performance, our ...

DN: 15 mm - 50 mm
Pressure: 4 bar
Temperature: -20 °C - 80 °C

... The pinch valves from Ross has a compact and economical design that is utilized for a broad range of applications in the industrial automation industries. It is ideally used for compressed air and other media. It is a lightweight device ...

DN: 15 mm - 250 mm
Pressure: 23.8 bar - 40 bar
Temperature: -10 °C - 400 °C

... control, flanged connections according to EN1092-1 PN 40 with prominence. Streamlined flow valves, Streamlined flow valves bellows type, Streamlined flow valves bellows type on carbon steel PN 40 - ...

DN: 10 mm - 80 mm
Pressure: 16 bar
Temperature: -20 °C - 80 °C

... nut Integrated bracket for fix point mounting Integrated fixations for the modular adapter set: one-piece injected valve body Cushion O-ring for PTFE-seat Double sealed shaft Locking handle with integrated PLS ...

DN: 20 mm - 150 mm
Pressure: 3.5 bar - 6 bar
Temperature: 135 °C - 180 °C

... For control of air, water, gas, steam in textile, power generator, paper & pulp, chemical, petrochemical industries, PSA nitrogen system, air dryers, gas generators & others. Upto 50 mm 300 cy/hr.,(tested on air,on other fluids this figure ...

DN: 0.25 in - 0.5 in
Pressure: 0 bar - 420 bar
Temperature: -20 °C - 400 °C

... The CP-06 offer a wide array of needle valves that are specifically constructed to be applied with liquids that both posses high pressure and temperature service. Fabricated from AISI-36 stainless steel, these valves' ...

DN: 15 mm - 50 mm
Pressure: 40 bar
Temperature: -30 °C - 140 °C

... ball valve to control the flow of hot and cold water and Glykol solutions (max. 50%) in HVAC systems conjunction with a rotary actuator Technical data Valve Flow disc : with and without flow disk Media ...

DN: 50 mm - 300 mm
Temperature: -29 °C - 177 °C

... 310 - Wafer high performance butterfly valve 312 - Lugged high performance butterfly valve High performance applications such as steam, chill water, water, utility lines, gasoline, ...

DN: 40 mm - 300 mm
Pressure: 10 bar - 16 bar

... Body: EN-JS1050 Coating: Epoxy Resilient-seated gate valves according to European standard EN 1171 with straight, smooth and non-constricted passage. Internally enamel, externally EKB. For water, air and non-aggressive ...

Pressure: 4.1 bar

... AMOT Model 4143 valve is used for sensing loss of coolant due to hose breakage, poor water flow due to excessive cavitation or worn pump impeller blades. Upon a dangerous condition, the pressure differential will decrease, ...

Pressure: 0 bar - 40 bar
Temperature: -30 °C - 230 °C

... worldwide. Modern precision manufacturing methods and the very best materials guarantee ROCKY valves to be of the highest quality and reliability. TPC valves and accessories were primarily developed for the rationalization ...

DN: 16 mm - 110 mm
Pressure: 16 bar
Temperature: 0 °C - 60 °C

... 100% factory tested. • Available in PVC-U or Corzan® CPVC. • Threaded seal carrier. • It allows the disassembling of the valve while maintaining system pressure. • Union ends for easy installation and removal. • Good mechanical strength. • ...

Pressure: 10 bar
Temperature: 135 °C

... Aseptomag® leakage valves ADV are the simplest form of mixproof shut-off valves. They are used at pipe junctions in aseptic processing plants for uncritical sterile products such as i.e. drinking water. A ...

DN: 10 in - 16 in
Pressure: 0.1 MPa - 0.8 MPa
Temperature: 1 °C - 42 °C

... electronic sensors to determine piston positions. “Totalizer” function tracks total amount of water treated. Audible Cycle Advance Alarm sounds if the valve is stuck in any position for more than 2 minutes. Self-charging ...

DN: 25 mm - 150 mm
Pressure: 0 bar - 10 bar

... Inexpensive shut-off fitting in the hygienic product and CIP section Solidly designed valve disk Safe guidance of the disk thanks to bushes in the housing Seal with a small volume and extension gaps for compensating temperature ...

DN: 2 mm - 16 mm
Temperature: -35 °C - 200 °C

... Pneumatic control valve VALVE STYLE Butterfly valve USAGE Throttling service Low-pressure service On/off service Hygienic service VERSION ANSI SUPPLY Pneumatic VALVE ...

DN: 8 mm - 20 mm
Pressure: 0 bar - 6 bar
Temperature: 95 °C - 150 °C

... is encapsulated diaphragm and CDSA sealing concept. it eliminates the water hammer and depends on the diaphragm material and it is neutral and aggressive with gaseous and liquid media. The flow can be in either direction ...

... ARAG® Manual Proportional Spray Control Valves Adjusts flow proportionally to control spray pressure. Key Features 473 Series outlet size: 1 1/4" HB ...

DN: 40 mm - 100 mm

... The flywheel valves are made primarily of aluminum alloy in a heat-treated, fire engine red finish. The other major components are made of stainless steel and galvanized brass. Some of the major characteristics of these ball valves ...

DN: 50 mm - 300 mm
Pressure: 6 bar - 16 bar
Temperature: -20 °C - 180 °C

... • wafer type butterfly valve designed according EN 593 • flange connections according EN 1092-2 - PN6/10/16, ASME/ANSI B16.5 class 150, ASME/ANSI B16.47 class 150 series A • face to face dimension according EN 558-1 series 20, ISO ...

DN: 40, 300 mm
Pressure: 10 bar
Temperature: -10 °C - 150 °C

... full bore • Gate valves are bi-directional and can be installed in any position. However, the preferred orientation is with the stem pointing vertically upwards. Field of application • Industrial plants • Sewage Water • ...

DN: 15 mm - 150 mm
Pressure: 16 bar
Temperature: -40 °C - 150 °C

... toxic Yi volatile gas and liquid process control. 850C lined PTFE corrosion resistant control valve, the valve body and the inner part of the whole lining of fluorine structure, effectively blocking ...

DN: 0.5 in - 6 in
Pressure: 10 MPa - 76 MPa
Temperature: -29 °C - 593 °C

... standard: ASME B16.34 Valve body material: WB36/A105/F22 Flow characteristics: E%/L Leakage level: ANCI FCI-02 V Product Features 1. - Good valve core stability. The sturdy and durable guide cylinder provides ...

DN: 15 mm - 100 mm
Pressure: 16 bar
Temperature: 0 °C - 60 °C

... EFFAST PVC-U valve BK1 is a true union ball valve ideal for heavy duty applications, chemical applications and water treatment. Technical features: Solvent welded sockets (ISO, BS, ASTM, JIS), threaded ...

DN: 15 mm - 25 mm
Pressure: 16 Pa
Temperature: 1 °C - 110 °C

... Valves used for control of hot and cold water in climate, heating and ventilation systems. They can also control glycol-mixed water in for example liquid connected recovery systems. Intended ...

DN: 2 in - 24 in
Pressure: 16 bar - 250 bar

... entry ball valves are used in piping systems where the top of the valve can be removed to gain access to the ball and seats without removing the entire valve from the piping system. Typically made from ...

DN: 0.5, 0.75, 1, 1.25 in
Pressure: 1.6 MPa
Temperature: 1 °C - 130 °C

... HTW-EG200 Series Motorized Ball Valves are used to control the on/off of heat/cool water air-conditioning system pipe to control the room temperature. The valve is driven by synchronous motor. The motor ...

DN: 40 mm - 1,200 mm
Pressure: 16 bar
Temperature: -20 °C - 180 °C

... possible misalignment and reduces overall height. SIDE FLANGE: Connection compatibility design allows RBV010 Series Butterfly Valve to be installed between flanges of DIN PN 10/16, BS and ASME Class 150 simultaneously. Bi-Directional ...

DN: 0.5 in - 2 in
Pressure: 16 bar
Temperature: 0 °C - 120 °C

... are required for potable drinking water as well as general industrial applications. Elephant electric actuated valves use power-to-open and power-to-close, stays in the last known position with loss of ...

DN: 40 mm - 300 mm
Pressure: 10, 16 bar
Temperature: -35 °C - 200 °C

... The KTN 266ITT is our butterfly valve with a wafer type connection, seat and ptfe disc . The ptfe seat and disc give the valve great resistance to corrosion . The range is from DN 40 to DN 300 , replacing the sleeve with ...