Magnetically coupled rodless pneumatic cylinder
16 - 25 mm, max. 7 bar
METAL WORK
The magnetic-slide rodless cylinder operates pneumatically and
is equipped with a piston and a slide with magnets. The slide
runs freely along the liner, following the piston movements, thanks
to the magnetic coupling force between the two.
If an axial force exceeding the magnetic coupling force is applied
to the slide, it disengages. It is therefore important to operate
within the pressure, force and speed ranges shown in the catalogue.
The load is fixed onto the slide using four threaded holes. The
cylinder is secured at the ends by means of nuts, flanges and
brackets.
This solution is recommended when there is limited space for
assembly, there must be no air leaks or impurities must be
prevented from entering. Available with three bores
016-20-25, in the basic or swinging versions, with adjustable
pneumatic cushioning or non-adjustable cushioning. Designed
for use with magnetic sensors.
is equipped with a piston and a slide with magnets. The slide
runs freely along the liner, following the piston movements, thanks
to the magnetic coupling force between the two.
If an axial force exceeding the magnetic coupling force is applied
to the slide, it disengages. It is therefore important to operate
within the pressure, force and speed ranges shown in the catalogue.
The load is fixed onto the slide using four threaded holes. The
cylinder is secured at the ends by means of nuts, flanges and
brackets.
This solution is recommended when there is limited space for
assembly, there must be no air leaks or impurities must be
prevented from entering. Available with three bores
016-20-25, in the basic or swinging versions, with adjustable
pneumatic cushioning or non-adjustable cushioning. Designed
for use with magnetic sensors.
