Electric valves

DN: 40 mm - 100 mm
Pressure: 150 mbar
Temperature: -20 °C - 450 °C

Solenoid actuators MB 7 and butterfly valves BVHM for staged control of industrial burners in cold or hot air Features & Benefits: For fitting between two flanges With spring-loaded valve ...

DN: 0.25 in - 1 in

... Solenoid Valve), please refer to HAM-LET Pneumatic Actuator Catalog ■ - For Stamless Steel Actuator or Electric Actuator please contact your local représentative The sélection of Valve-Actuator ...

DN: 15 mm - 50 mm
Pressure: 16 bar
Temperature: 2 °C - 170 °C

V5013E Series linear control valves are 3-way mixing control valves suitable to regulate hot and chilled water flow across a wide range of KVS requirements. V5013E 3-way Linear Valves ...

DN: 15, 20, 10, 25, 32 mm
Temperature: -40 °C - 120 °C

The MVS industrial electronic control valve utilizes electronic controls to regulate both liquid and vapor refrigerant flows. The MVS electronic control valve ...

DN: 15 mm
Pressure: 4,500,000 Pa
Temperature: -40 °C - 120 °C

Hermetically sealed 2-port valves for modulating control of chillers and heat pumps. Expansion, hot-gas and suction throttle applications with one type of valve PS45, stainless steel with soldering ...

DN: 40 mm - 1,000 mm
Pressure: 10 bar - 25 bar
Temperature: -10 °C - 200 °C

Centred-disc butterfly valve, sealed by elastomer liner, with lever or manual gearbox, pneumatic, electric or hydraulic actuator. Wafer-type body (T1), semi-lug body (T2), full-lug body (T4) or U-section ...

DN: 20 mm - 150 mm
Pressure: 52 bar
Temperature: -60 °C - 120 °C

The ICM motor operated valves from Danfoss ICV Flexline™ series are quick and simple to handle, install and service due to their low weight and compact design. The valve is designed to ...

Pressure: 0 bar - 8 bar
Flow rate: 350, 1,600 l/min

... electrical power consumption (no self-heating) Control from 0 bar (vacuum version available) High pressure control stability The piezo-controlled proportional valves of the Tecno series are 3-way ...

DN: 0.5 in - 2.125 in
Pressure: 680, 700 psi
Temperature: -40 °F - 240 °F

Parker-Sporlan’s CDS valves are stepper motor actuated electric valves intended for use in direct expansion refrigeration and air conditioning applications. CDS valves ...

DN: 31.8 mm

The Fisher D4 control valve is a compact, rugged globe valve designed primarily for high-pressure, throttling applications using either pneumatic or electric control. This valve ...

DN: 15 mm - 50 mm
Pressure: 25 bar
Temperature: -15 °C - 200 °C

Special features • - Consisting of single-seated globe valve and actuator • - Flanges or male thread connection and welding or threaded ends or female thread connection Accessories • - Type 2 NI Strainer Options ...

DN: 0.25 in
Pressure: 3 bar - 10 bar
Temperature: -10 °C - 50 °C

... the adjustment needle valve. The piston opens the main valve when the downstream side of the valve reaches approximately 60% of the supply pressure. The ramp up time to reach the switch-over ...

DN: 40, 50 mm
Pressure: 0.5 bar - 10 bar

The BERMAD Pressure Reducing Control Valve with Solenoid Control is a hydraulically operated, diaphragm actuated control valve that reduces higher upstream pressure to lower constant downstream pressure ...

DN: 1 in - 2.5 in
Pressure: 9 bar - 70 bar
Flow rate: 40 l/min - 1,200 l/min

... Description The Servo Electronic Valve (SEV) is controlled by closed loop digital electronics, providing consistent acceleration and deceleration of hydraulic elevators largely independent of load and ...

DN: 15 mm - 150 mm
Pressure: 3, 16 bar
Temperature: 220 °C

High precision pressure reducing valve with motorized actuator for remote operation (with built-in separator and trap) Benefits and Features Easy to Use A motorized actuator is ...

... factors such as the flow conductance and leak-tightness of valves are of great importance. The valves of Leybold are optimized with regard to these demands. For every flange system there are a lot of ...

Pressure: 140 Pa - 840 Pa
Temperature: 1 °C - 42 °C
Flow rate: 4,500, 5,900 l/h

... installation and service. Reliable and precise electronic sensors to determine piston positions. “Totalizer” function tracks total amount of water treated. Audible Cycle Advance Alarm sounds if the valve ...

DN: 1.5, 0.75, 0.5, 1 in
Temperature: 10 °C - 70 °C
Flow rate: 10 l/min - 250 l/min

40Ω Series Proportional Electro-Hydraulic Flow Control (and Check) Valves – The preselected flow varies in proportion to the current input, the selected flow is not affected by pressure or flow. For other ...

... rod. That’s because the engineers behind the Olmsted valves provided by Oilgear developed a proprietary means of achieving the majority of the features of the electro-hydraulic ARV without electronic ...

DN: 80, 100 mm
Pressure: 0.2 MPa - 0.6 MPa
Temperature: -25 °C - 55 °C

... the upper and lower ends. Finally, the compressed air in the seven packs (sub-chambers) is ejected from the outlet of the valve to achieve the purpose of ash removal. Through the action of the pilot part 1, compressed ...

DN: 0.25, 0.5 in
Pressure: 40 bar
Temperature: -40 °C - 100 °C

... meters red-y compact series. Tightly Closing Valves The valves are tight-closing Different Device Setups The valves are available as straight valves or valve ...

DN: 15 mm - 50 mm
Pressure: 40 bar
Temperature: -30 °C - 140 °C

... horizontal (in relation to shaft) Materials Case : brass (DIN EN 12165, CW617N) Valve ball : stainless steel (EN 10088-2) Valve shaft : stainless steel (EN 10088-2) Valve shaft gasket ...

DN: 50 mm - 600 mm
Pressure: 16, 10 bar
Temperature: 100 °C

Resilient-seated, lug-type butterfly valve for flange mounting to pipelines; disk with centric bearing; suitable for use in sea water applications. With replaceable liner mounted on a vulcanised seal carrier ring, and ...

DN: 10 mm - 50 mm
Pressure: 25 bar
Temperature: 0 °C - 120 °C

... max. Δp over the valve Versions with and without pressure measurement nipple The valve is closed when the spindle is moved in Closing against the pressure Slight adaptation of the proven SAUTER actuator ...

DN: 50 mm - 1,400 mm
Pressure: 400 bar
Temperature: -196 °C - 450 °C

The ideal valve to minimise any risk of fugitive emissions from flanges in the natural gas and oil industry. The Fig. 5600 valves have been designed for gas transportation and gas distribution applications. ...