DN: 25 mm - 150 mm
... generation New, shorter lanterns Shortened vertical socket on the valve configurations "L" and "T" Advantages of the ECOVENT® valves: Use of the established and proven VARIVENT® valve housing VARIVENT® ...
DN: 25 mm - 100 mm
Pressure: 10 bar
Temperature: -10 °C - 25 °C
... numerous options and variations available Optimization of process efficiency Serviceable actuator BBZK is a modulating valve designed to regulate the flow rate and maintain a constant level, pressure or temperature value. Its special ...
DN: 2.5, 2 mm
Pressure: 0 bar - 12 bar
Flow rate: 1.6 l/min
... proportional valve with cartridge connection and 21 mm outer diameter. Suitable for air, oxygen and inert gases. Available nominal sizes: 2.0 mm (standard) and 2.5 mm (option). Voltages: 12 V DC (standard) and 24 V DC (option). Electrical ...
DN: 1 in - 2.5 in
Pressure: 9 bar - 70 bar
Flow rate: 40 l/min - 1,200 l/min
... Description The Servo Electronic Valve (SEV) is controlled by closed loop digital electronics, providing consistent acceleration and deceleration of hydraulic elevators largely independent of load and oil temperature. ...
DN: 0.125 in
Pressure: 0 bar - 34.5 bar
Temperature: 0 °C - 121 °C
... low flowrates of liquids and gases, MFV™ Barstock valves are available in six conveniently overlapping orifice-needle sizes. Offered in straight (T) and 90 degree (L) flow patterns, the MFV™ Barstock Valve includes a ...
Aalborg Instruments
DN: 0.5, 0.75, 1 in
Pressure: 1.6 MPa
Temperature: 0 °C - 90 °C
... temperature controller will automatically cancel the output signal, and the motorized heating valve will turn off slowly, cutting off the water source. FC300 series motorized heating valves ...
Taloar
DN: 1 mm
Pressure: -70,000 Pa - 200,000 Pa
Temperature: 5 °C - 80 °C
... only to proportional valves. The advantages of minimal space occupancy, fast response, small internal diameter, and small influence on fluidic system fluctuations are definitely your best choice. Feature of SD61 2-Way Miniature Valve Structural ...
Keyto Fluid Technology
DN: 10 mm
Pressure: 0.2 bar - 10 bar
Temperature: 5 °C - 60 °C
... industrial applications, containers are usually kept at a constant filling level by using float valves. Valves of this design are 2-chamber globe valves and have an additional back flow preventer to ...
A. u. K. Müller
DN: 30, 25, 18 mm
Pressure: 6 bar - 420 bar
Temperature: -20 °C - 90 °C
... various manifold valve plate configurations Design characteristics directional control valves available as sub plate mounted valves nominal sizes 18, 25 and 30 modular design for ...
DN: 10 mm - 50 mm
Pressure: 25 bar
Temperature: 0 °C - 120 °C
... max. Δp over the valve Versions with and without pressure measurement nipple The valve is closed when the spindle is moved in Closing against the pressure Slight adaptation of the proven SAUTER actuator technology Regulating ...
Pressure: 3 bar - 10 bar
... This valve has been designed to control lubricant flow (oil and grease). Piston is made of hardened and ground steel. It is driven by a pneumatic cylinder controlled by a 4-way solenoid valve. This device is normally ...
Dropsa spa
DN: 10 mm - 80 mm
Pressure: 16 bar
Temperature: -20 °C - 120 °C
... Modular design Silicon-free Buttress thread for perfect fit of the union nut Integrated bracket for fix point mounting Easy switch between different configurations due to special features and fitting devicesions due to special features ...
Praher Plastics Austria GmbH
DN: 12.5 mm - 1,200 mm
Pressure: 10 bar - 100 bar
... valves. Ball segment valves work well for this purpose because of the one-piece design of the ball segment and valve shaft. Butterfly valves are also very suitable as control valves. Ball ...
DN: 50 mm - 300 mm
Pressure: 0 bar - 10 bar
Flow rate: 90 m³/h - 3,498 m³/h
... B16.5, Cl.150. Characteristic: On-Off. For Air, Water, Oil, Gas, some Chemicals, Low pressure steam. Valve can be used on Combustion Equipments, Power Stations, Chemicals, Petro-chemicals, Pharmaceuticals and Textile ...
DN: 15 mm - 50 mm
Pressure: 40 bar
Temperature: -30 °C - 140 °C
... horizontal (in relation to shaft) Materials Case : brass (DIN EN 12165, CW617N) Valve ball : stainless steel (EN 10088-2) Valve shaft : stainless steel (EN 10088-2) Valve shaft gasket : 2 x EPDM O-ring Gasket ...
GRUNER
DN: 0.5 in - 56 in
... forged steel gate valves. Its gate valve iron gate are resilient or metal-made with metal-seated, PN10 to PN16 or ANSI 150, sizes ½” to 40”. It also provides an ANSI 150, 300, 600, 1500, 2500, sizes 2” to 56” materials ...
FAMAT
DN: 50 mm - 600 mm
Pressure: 16, 10 bar
Temperature: 100 °C
... Resilient-seated, lug-type butterfly valve for flange mounting to pipelines; disk with centric bearing; suitable for use in sea water applications. With replaceable liner mounted on a vulcanised seal carrier ring, and disk with triple ...
VAG-Group
DN: 50 mm - 1,400 mm
Pressure: 400 bar
Temperature: -196 °C - 450 °C
... The ideal valve to minimise any risk of fugitive emissions from flanges in the natural gas and oil industry. The Fig. 5600 valves have been designed for gas transportation and gas distribution applications. Standard ...
Pentair Valves & Controls
... is also supplied with inline structures, safety shut off valves and soft start valves. In addition, the pressure control valve is available with pendulum, butterfly, vane and poppet throttle valves ...
DN: 3 mm - 8 mm
... Chalwyn SVX Electric Actuated Butterfly Air Intake Shutoff Valve is available with three different methods of electric actuation described below. The descriptions include the available models for each ...
AMOT
DN: 50 mm - 200 mm
Pressure: 10 bar
Temperature: 10 °C - 80 °C
... every 15º with position holding. • Good mechanical strength. • Built in lockout feature to prevent undesired operations. • Electric and pneumatic actuators available, and with gear box. ...
Cepex SER
Pressure: 10 bar
Temperature: 150 °C
... single-seat control valves are used for the exact setting and control of parameters such as flow, pressure, temperature, or filling level in aseptic processing plants. An electro-pneumatic positioner enables the exact setting of the ...
DN: 0.5, 0.75, 1 in
Pressure: 250 psi
Temperature: 400 °F
... The Motorized Ball Valve delivers a torque of 150 in-lbs using a non-reversing motor, opening the valve in 5 seconds and minimizing pressure hammer. The motor is protected in a NEMA 4X ...
... factors such as the flow conductance and leak-tightness of valves are of great importance. The valves of Leybold are optimized with regard to these demands. For every flange system there are a lot of valve ...
Leybold
Pressure: 140 Pa - 840 Pa
Temperature: 1 °C - 42 °C
Flow rate: 4,500, 5,900 l/h
... installation and service. Reliable and precise electronic sensors to determine piston positions. “Totalizer” function tracks total amount of water treated. Audible Cycle Advance Alarm sounds if the valve is stuck ...
OB Telecom Electronics Co.,Ltd.
DN: 1.5, 0.75, 0.5, 1 in
Temperature: 10 °C - 70 °C
Flow rate: 10 l/min - 250 l/min
... 40Ω Series Proportional Electro-Hydraulic Flow Control (and Check) Valves – The preselected flow varies in proportion to the current input, the selected flow is not affected by pressure or flow. For other products visit ...
YUKEN Europe Ltd.
... rod. That’s because the engineers behind the Olmsted valves provided by Oilgear developed a proprietary means of achieving the majority of the features of the electro-hydraulic ARV without electronic controls. Product ...
DN: 80, 100 mm
Pressure: 0.2 MPa - 0.6 MPa
Temperature: -25 °C - 55 °C
... the upper and lower ends. Finally, the compressed air in the seven packs (sub-chambers) is ejected from the outlet of the valve to achieve the purpose of ash removal. Through the action of the pilot part 1, compressed air enters the ...
Zhejiang Gute Pneumatic Machinery Co., Ltd
DN: 0.25, 0.5 in
Pressure: 40 bar
Temperature: -40 °C - 100 °C
... meters red-y compact series. Tightly Closing Valves The valves are tight-closing Different Device Setups The valves are available as straight valves or valve ...
DN: 40 mm - 300 mm
Pressure: 10, 16 bar
Temperature: -15 °C - 130 °C
... B24: Mono 230V/50Hz Disc material Ductile iron GGG50 coated Connection between flanges Operating system BERNARD electric actuator ...
TECOFI
DN: 2 in - 40 in
Pressure: 0.6 MPa - 16.5 MPa
Temperature: -29 °C - 150 °C
... The electric valve use part-turn rotary electric actuators because the working angle of a ball valve is typically 90 degrees, and is very popular as electric actuated ...
Athena Engineering S.r.l.
DN: 50 mm - 1,500 mm
Pressure: 1, 1.6, 2.5 MPa
... changes in temperature and pressure Installable Accessories Solenoid Valve Limit Switch Air-Filler Regulator Pneumatic Valve, Fast Vent Valve, Speed Control Valve ...
ROPO GmbH
DN: 50 mm - 3,500 mm
Temperature: 0 °C - 600 °C
... High Performance Wafer Butterfly Valve Fabricator: High Performance Butterfly Valves, Wafer Type, 2-140 Inch, 50-3500mm, 150-1500 LB, CS, SS, Aluminium Bronze. The Med Wafer High-Performance Butterfly Valves ...
China MED Valve Co., Ltd.
Pressure: 0 bar - 10 bar
Temperature: 0 °C - 50 °C
Flow rate: 290 l/min - 4,800 l/min
... control valves - Series EPR Proportional valves, series EPR, are used in the field of pneumatics (compressed air) and allow the adjustment of the output pressure by means of an electrical signal. Depending ...
DN: 15 mm - 100 mm
Pressure: 16 bar - 40 bar
Temperature: -10 °C - 200 °C
... Flanged EN or ASA 2 ways linear control valve available in different materials and pressure ranges with electric, electro pneumatic or pneumatic action. ...
DN: 0 mm - 10,000 mm
Pressure: 14 bar
Temperature: 71 °C
... Operation & linkage
The
valves use a free‑fall linkage (dead weight / drop arm) that allows the weight to gain momentum before releasing the
valve lever, ensuring a rapid and reliable mechanical actuation.
Valve ...
... need to integrate your actuators into your valve interlock operating procedures and sequences. Using MOV interlocks, you can regulate the components of an actuator, mechanically locking (blocking) the power switch ...
DN: 0 mm - 10,000 mm
Pressure: 6 bar - 64 bar
... request).
AVAILABLE VERSIONS
- Standard wafer valve
- Wafer valve with gearbox/box
- Motorized wafer valve with gearbox/box
- Motorized wafer valve
DN: 40 mm - 1,600 mm
Pressure: 2.5 bar - 100 bar
Temperature: -10 °C - 200 °C
... the request of customers . The gate valve body is made of cast steel and it is suitably dimensioned to assure a high safety factor. The thicknesses are always higher than the mini-mum ones established for GATE VALVE ...
DI NICOLA INFINAM
Pressure: 5 bar - 30 bar
Temperature: 10 °C - 50 °C
... DS dosing system via a cable set of up to 20 meters in length. Advantages The PDV04 is viscosity-, pressure- and temperature-independent and ensures extremely process-safe metering thanks to electronic monitoring ...
Dosier- und Prüftechnik GmbH
the best suppliers