Power amplifier ATA-M2

voltagedigitalsingle-channel

ATA-M2 Power Amplifier
Maximum Output Voltage: 175Vrms
Maximum Continuous Output Power: 200VA
Maximum Pulse Output Power: 500VA, 10%@1S
Bandwidth (-3dB): 10kHz~500kHz
Over Temperature Protection, Over Voltage Protection, Short Circuit Protection, and No Load Protection
INTRODUCTION
The ATA-M2 is an ideal single-channel power amplifier. It delivers a maximum output voltage of 175Vrms, continuous power of 200VA, and pulse power up to 500VA. It is capable of driving 0~100% of both resistive and non-resistive loads. The output impedance is matched with multiple selectable ranges, allowing users to adjust according to specific testing requirements.
LCD PANEL DISPLAY
The ATA-M2 features an LCD screen that dynamically displays device status and parameters. The user interface is intuitive, clear, and easy to understand, ensuring a user-friendly experience.
INPUT
Single-ended input with a BNC connector; the input signal's valid value must not exceed 1Vrms.
MONITOR
Output Current Monitor: 100mV/A Output Voltage Monitor: 10mV/V
The output monitoring port uses a BNC connector and can be directly connected to an oscilloscope for real-time monitoring.
OUTPUT
The output impedance is matched with multiple selectable voltage ranges. According to testing requirements, the output can be adjusted by setting the desired voltage percentage (0~100%) within the corresponding range. The device is equipped with protection features against over-temperature, over-voltage, short-circuit, and no-load conditions. The LCD panel displays the current protection status, and output can only resume after the fault has been cleared.
Output Impedance Matching Adjustment Ranges