Slewing drive SE9

worm gear worm shaft slewing drives are used in the field of industrial automation. A left input slewing drive and a right input slewing drive are installed and used relatively vertically, the motors are all facing the outside of the device after installation. During the model selection, we always hear from customers that vertical installation and use of slewing drives are prone to various problems. For example, the two slewing drives jointly drive a workpiece to be rotated. Customers are worried that the two slewing drives can’t be synchronized, resulting in the inability to rotate. They were also concerned that the two worm shaft slewing drives couldn’t be synchronized when rotating, resulting in stuck. Customers have such concerns either because they have had similar problems in the previous use process or they are worried that there will be problems when they use for the first time. We often encounter these working conditions and the feedback on the use of our products sent to customers is good. As long as the models are properly selected and the product qualities are good, the slewing drives can be installed and used vertically. The two slewing drives drive a workpiece to rotate at the same time and the synchronization can be easily achieved by using a hydraulic motor or a servo motor. It only needs to reasonably control the hydraulic motor or servo motor to synchronize. The double worm shaft slewing drives can also be driven by hydraulic motors or servo motors to achieve synchronous and smooth rotation.